Structural Concepts Fusion GMGV4 handleiding

Niet gecategoriseerd

Structural Concepts

43 pagina's

PDF beschikbaar

Handleiding

Warning! Disconnect power before providing

maintenance and service to unit.

Caution: Lamps are treated to resist breakage and

must be replaced with similarly treated lamps.

Note: Warranty will be void if claims arise from

negligence, misuse of goods, extreme environmental

conditions or improper maintenance. See Overview

And Warnings section in manual.

2. Rear Sliding Doors

Note: Doors are not interchangeable. There is an inner

and outer door. Outer door must be removed first and

replaced last.

• The outer door is the right hand door (from service

side or rear of case).

• Move doors toward the center of the case.

• Individually lift each door up toward the top of the

case; pivot the bottom of the door out.

• Replace rear sliding doors in reverse order they were

removed.

3. Light Fixtures

Note: Depending upon model and options, light fixtures

can have either single or dual lamps.

Light fixtures are located on underside of shelf

assemblies and at the top inside of case. See illustration

at upper right for locations.

Removal of lamps:

• Rotate lamp (1/4-turn) to disengage (upper or lower)

pins/contacts from mounting sockets.

• Remove bulb by applying even pressure from back

side at the bulb ends and pulling the remaining

contact from sockets.

• See illustrations at mid and lower-right.

Installation of lamps:

• Align pins with slot.

• Insert pins into socket by rotating the bulb 1/4-turn to

secure either the (upper or lower) pin contacts into

the sockets.

• Rotate remaining bulb contacts (1/4-turn) into

remaining lamp mounting socket contacts.

• See illustrations at right.

4. Supplemental Flood Lighting / Food

Lighting Specifics / Cautionary Note

• Avoid using supplemental flood or spot lighting.

• Display light intensity has been designed for

maximum visibility and product life at the factory.

MAINTENANCE FUNDAMENTALS, CONT’D: REAR SLIDING DOORS / T-8 LIGHTS / FLOOD LIGHTS

Light

Fixtures

• Caution! The use of higher output

fluorescent lamps (H.O. and V.H.O.), will

shorten the shelf life of the product,

causing ‘product browning.’

• Bulbs must be replaced with similar wattage,

output and design as those in which the unit

was equipped with from the factory.

>> See next page for LED light fixture

information.

Bekijk gratis de handleiding van Structural Concepts Fusion GMGV4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.