Structural Concepts Fusion GMG4 handleiding

Niet gecategoriseerd

Structural Concepts

43 pagina's

PDF beschikbaar

Handleiding

MAINTENANCE FUNDAMENTALS, CONT’D: CUTTING BOARD AT REAR LEDGE / PAPER ROLLER

7. Cutting Board (Rear Ledge) Removal Steps

The illustrations at right and below reflect step-by-step

removal method.

1. Hinged support bracket is shown in its standard

upright position.

2 & 3. While upright, rear ledge (cutting board) must be

slid away from case and then rotated downward to

vertical position.

3 & 4. From the shelf’s lowered position, lift from bottom

edge upward to disengage shelf track; attached rear

ledge (cutting board) from bracket.

8. Rear Ledge Raising and Lowering

• Illustration below shows rails and pins at underside

of rear ledge (cutting board).

• Pull pins and adjust ledge height. Replace pins.

————— Rear Ledge Removal Steps —————

Note: For clarity, only Shelf Track is shown being

removed. Rear Ledge is attached to Shelf Track.

Hinged

Support

Bracket

Shelf

Track

-1- -2- -3- -4-

Hinged

Support

Bracket

Paper Roller

(Optional)

Rail/Pin Mechanism For Raising

& Lowering Rear Ledge (Typ.)

9. Paper Rollers (Optional)

• Paper roller unit is

usually positioned under

rear ledge (cutting board).

• See illustration at right for

general location.

Bekijk gratis de handleiding van Structural Concepts Fusion GMG4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.