Structural Concepts Fusion GMDSV4D handleiding

Niet gecategoriseerd

Structural Concepts

35 pagina's

PDF beschikbaar

Handleiding

TROUBLESHOOTING - TO BE PERFORMED BY STORE PERSONNEL (UNLESS NOTED OTHERWISE)

CONDITION TROUBLESHOOTING

Case Lights Not Working Check that light switch has been flipped on.

Check bulbs for proper installation and connection.

Check for burned out bulbs.

Clean dirt and dust from the bulbs to prevent flickering.

Not Holding Temperature If a large amount of warm product was added to the case, it will take time for

the temperature to adjust. Unit needs product to be pre-chilled.

Temperature changes during defrost mode but will return to normal. Fourth

LED will indicate defrost cycle in progress.

Check that case is not in sun or near a heat or air-conditioning vent.

If case is located near outside doors, temperature fluctuation can hinder unit’s

ability to maintain temperature.

Check that condenser coil has been cleaned.

Check air return grilles for obstructions.

Trained Service Providers Only: Check sight glass for flashing and/or low

charge.

Trained Service Providers Only: Check set point temperature; it may be

adjusted too high.

Condensing Unit Is Not

Operating

Check that the power is turned on.

Determine if temperature controller settings are properly set. See your case’s

serial label for your model’s specified settings. See SERIAL LABEL

LOCATION & INFORMATION LISTED / TECH INFO & SERVICE section in

manual for label location, etc.

Bekijk gratis de handleiding van Structural Concepts Fusion GMDSV4D, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.