Structural Concepts Fusion GLDSV6R handleiding

Niet gecategoriseerd

Structural Concepts

37 pagina's

PDF beschikbaar

Handleiding

PREVENTIVE MAINTENANCE - TO BE PERFORMED BY TRAINED SERVICE PROVIDERS ONLY

PREVENTIVE

MAINTENANCE

FREQ. INSTRUCTIONS

Case Exterior Quarterly

Condensing Coil:

 Remove rear grille to access area. Simply lift up and off.

 Roll/slide out condenser package. Note: At initial slide-out, it may be

necessary to remove two (2) compressor pan shipment screws to slide

it out from under case.

 Warning! Coil fins are sharp. Handle with care!

 Caution! Airborne dust can contaminate food! Use wet rags to

cover area where air pressure is blowing.

 Use air pressure or industrial strength vacuum; clean dust and dirt that

may collect on condenser coil.

 Slide/roll condensing package back under case.

 Return rear grille to case.

Quarterly Under Case Cleaning: Once refrigeration package is clear of unit,

vacuum under case to remove all dust and dirt that collects under case.

Case Interior Quarterly Tub, Coil, Drain, Evaporator Fans, Brackets:

 Remove decking.

 Use vacuum to clean entire area.

 After vacuuming, clean area with warm water, clean cloth, and mild

soap solution.

 Remove any debris that may clog drain.

Quarterly Refrigeration Package/Compressor Area (Self-Contained Units Only):

Caution! Be certain to disconnect power from case before cleaning

refrigeration package!

 Warning! Overflow condensate pan Is HOT! Disconnect power from

case and allow to cool before cleaning evaporator pan!

 Slide/roll compressor package out from under case.

 Use a scrub-brush and a de-scaling solution such as CLR® (to

prevent corrosion, lime and rust). Follow instructions as to proper

dilution, safety precautions and scrubbing method.

 After thoroughly cleaning pan with scrub-brush and solution, rinse

thoroughly with clean water (in spray bottle) and wipe dry with sponge

or paper towel.

 Use moist cloth to wipe off dust & debris that collects on various parts

(fans, sight glass, overflow pan, etc.).

 Slide refrigeration assembly back under case.

 Replace front panel and lower grille via hooks (no screws required).

WARNING! TURN OFF CASE BEFORE PERFORMING PREVENTIVE MAINTENANCE!

Bekijk gratis de handleiding van Structural Concepts Fusion GLDSV6R, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.