Structural Concepts Fusion GLDSS543R handleiding

Niet gecategoriseerd

Structural Concepts

38 pagina's

PDF beschikbaar

Handleiding

CONDITION TROUBLESHOOTING

Control Display Is

Flashing

See your case’s serial label for your model’s specified settings. See SERIAL

LABEL LOCATION & INFORMATION LISTED / TECH INFO & SERVICE for label

location, etc.

See the Carel® Controller thermostat sheets in this manual for codes that may be

displayed on controller identifying problem.

Case Is Not Holding

Temperature

If a large amount of warm product was added to the case, it will take time for the

temperature to adjust. Unit needs product to be pre-chilled.

Temperature changes during defrost mode but will return to normal. Fourth LED

will indicate defrost cycle in progress.

Check that case is not in sun or near a heat or air-conditioning vent. See

OVERVIEW / TYPE / COMPLIANCE / WARNINGS / PRECAUTIONS / CORDS /

WIRING section in manual for adverse conditions/spacing issue parameters.

If case is located near front doors, temperature fluctuation can hinder unit’s ability

to maintain temperature. See OVERVIEW / TYPE / COMPLIANCE / WARNINGS /

PRECAUTIONS / CORDS / WIRING section in manual for adverse conditions/

spacing issue parameters.

Check that condenser coil air filter (attached to rear grille) has been cleaned. See

GENERAL CLEANING (TO BE PERFORMED BY STORE PERSONNEL) section

in operating manual for instructions.

Check that condenser coil has been cleaned.

Check air return grilles for obstructions.

Check sight glass for flashing and/or low charge.

Check Set Point Temperature; it may be adjusted too high.

Condensing Unit Is

Not Operating

Check that the power is turned on.

Determine if temperature controller settings are properly set. See your case’s

serial label for your model’s specified settings. See SERIAL LABEL LOCATION &

INFORMATION LISTED / TECH INFO & SERVICE section in manual for label lo-

cation, etc.

TROUBLESHOOTING (TO BE PERFORMED BY TRAINED SERVICE PROVIDERS ONLY) - PAGE 3 of 3

Bekijk gratis de handleiding van Structural Concepts Fusion GLDSS543R, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.