Structural Concepts Fusion GLDSS543R handleiding

Niet gecategoriseerd

Structural Concepts

38 pagina's

PDF beschikbaar

Handleiding

CLEANING SCHEDULE (TO BE PERFORMED BY STORE PERSONNEL)

AREA FREQ. INSTRUCTIONS

Exterior Daily Condenser Coil: Vacuum or brush condenser coil at case rear (after removing rear

grille).

Daily Top Board or Work Counter (Optional in Rear ‘Push-Up’ Work Counter): Clean

with a warm water and mild soap solution and soft cloth.

Daily End Glass / Glass Sneeze Guard on Rear ‘Push-Up’ Work Counter(Optional):

Clean with a household or commercial glass cleaner. Wipe dry with clean, dry

cloth or paper towel.

Daily Butcher Block: See BUTCHER BLOCK CLEANING INSTRUCTIONS (TO BE

PERFORMED BY STORE PERSONNEL) for cleaning specifics.

Daily Avonite Solid Surface: See AVONITE SURFACE CLEANING, CARE &

MAINTENANCE (TO BE PERFORMED BY STORE PERSONNEL) for cleaning

specifics.

Daily Stainless Steel: CLEANING SCHEDULE: STAINLESS STEEL (TO BE

PERFORMED BY STORE PERSONNEL) section in manual for specifics.

Weekly Acrylic Sneeze Guard: Clean with a warm water and mild soap solution and soft

cloth. Never use ammonia-based cleaners on acrylic.

Monthly Rear Sliding Doors (For Storage Area):

>> Door: Wipe down with warm water and mild soap solution and soft cloth.

>> Door Tracks: Use vacuum to remove dust, dirt and other residue that is in door

tracks. Then wipe down with warm water and mild soap solution and soft cloth.

Quarterly Adjustable Scale Stand: See ADJUSTABLE SCALE STAND section in manual.

• To clean butcher block, see next page.

• Remove adjustable scale stand by loosening thumbscrews, loosening all six (6)

retaining screws and lifting off merchandiser.

• Caution! Use only hand-held Phillips™ screw driver to loosen retaining

screws (at underside of adjustable scale stand). Do not use power driver!

• If unable to lift off merchandiser, it may be necessary to entirely remove inner

retaining screws.

• Submersed in warm, soapy water. Use nylon bristled brush and/or soft cloth to

remove residue.

• Rinse. Dry thoroughly before returning to merchandiser.

Interior Weekly Decks, Steps and Shelf Area (Optional in Rear ‘Push-Up’ Work Counter): Wipe

off components with moist cloth. For stubborn, hardened residue, remove from case

and submerse in warm, soapy water; use soft-bristled brush to remove residue.

Rinse. Dry with paper towel or clean cloth. Return to case.

Monthly Air Return Grille and Fan Shroud Area: 1) Turn off power. 2) Remove decks

from case. 3) Clean with moist cloth. See Maintenance Fundamentals that pertain

to Evaporator Fans, TXV and Drain Access for illustration.

Bekijk gratis de handleiding van Structural Concepts Fusion GLDSS543R, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.