Structural Concepts Fusion GLDSS443R handleiding

Niet gecategoriseerd

Structural Concepts

38 pagina's

PDF beschikbaar

Handleiding

PREVENTIVE MAINTENANCE (TO BE PERFORMED BY TRAINED SERVICE PROVIDER) - Page 1 of 2

PREVENTIVE

MAINTENANCE

FREQUENCY INSTRUCTIONS

Case Exterior Monthly Condenser Coil: Disconnect power from case before cleaning the

Condenser Coil!

• Remove Rear Grille (by removing 4 screws).

• Roll / Slide out Refrigeration Assembly. Note: At initial slide-out, it

may be necessary to remove two (2) Compressor Pan Shipment

Screws for Refrigeration Assembly to slide out.

• Use air pressure or industrial strength vacuum; clean dust and dirt

that may collect on the Condenser Coil. See illustration below.

• Caution! Coil fins are sharp. Handle with care!

• Slide/Roll Condenser Unit Assembly back under case.

• Replace Rear Grille to case (4 screws).

• See illustration below.

Quarterly Optional Clean Sweep™ Condenser Coil: Disconnect power from

case before cleaning Clean Sweep™ Condenser Coil!

• Remove Rear Grille (by removing 4 screws).

• Slide/Roll out condensing unit assembly.

• Remove the four (4) screws holding the Clean Sweep™ rails intact.

• Remove the Clean Sweep™ rail.

• Wash rails’ brushes in hot water and mild soap solution.

• If brushes are worn, they must be replaced. Call Technical Service

Department to replace. Toll-Free number is listed at end of

manual.

• Clean Condenser Coil: Use air pressure or industrial strength

vacuum; clean the dust and dirt that may collect on the Condenser

Coil.

• Caution! Coil fins are sharp. Handle with care!

• Reattach Clean Sweep rail to condensing unit (4 screws).

• Slide/Roll Condensing Unit Assembly back under case.

• Replace Rear Grille to case (4 screws).

• See photos below.

(4) Screws

--- Above photos are taken after rear grille has been removed from case ---

Brushes

Rail

Bekijk gratis de handleiding van Structural Concepts Fusion GLDSS443R, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.