Structural Concepts Fusion GJDSS6RLB handleiding

Niet gecategoriseerd

Structural Concepts

25 pagina's

PDF beschikbaar

Handleiding

INSTALLATION: DISPLAY CASE START-UP / LIGHTS / THERMOMETER / TEMP. CONTROLLER

15. Case Start-Up

• Case will power-up when properly field wired (or

plugged in).

• After case is powered up, lift decking by simply

lifting up (no screw removal required) to confirm

that axial fans are running.

• See next page for illustrations.

16. Light Fixtures

Light fixtures are located above honeycomb air

diffuser (as shown at right).

Warning! Disconnect power before providing

maintenance and service to unit.

Caution: Lamps are treated to resist breakage;

replace with similarly treated lamps.

Mini-LED Style Light Fixtures

Removal of lamp:

• If case is provided with mini-LED lights, they will

rarely require change-out.

• Contact Structural Concepts’ Technical Service

Department for replacement parts (see the

Technical Service section of operating manual).

Replacement of lamp:

• To replace LED light fixture, simply disconnect the

existing LED light from its brackets. Replace.

• Note: LED light and plug must be connected in a

specific manner or they will not work.

• Make certain oval edge of plug connects to oval

edge of LED light.

• See illustrations at right.

17. Light Switch

• Turn on lights with switch located near

thermometer (as shown below).

• To conserve energy, turn off lights when not

needed.

18. Thermometer

• Thermometer is located near LED light switch.

• Thermometer does NOT reflect actual food

temperatures; it is ONLY for monitoring warmest

air temperature in merchandiser.

• Food probes must be used to measure actual

food temperatures.

19. Temperature Controller

• Temperature controller is located at front left

behind lower front panel.

• Temperature controller is provided by customer.

LED Light

Switch

Mini-LED Light

Thermometer

Dixell®

Display

• See store manager for operating instructions for

your unit’s temperature controller (thermostat).

• Check that compressor symbol light is on.

• Compressor will likely be identified with:

• After case has run for a few minutes, check that

temperature starts to drop.

• If temperature controller does not begin cooling

unit (in a few minutes) see temperature controller

owner’s manual for instructions.

LED Light

Plug

LED’s Barrel

Shaped Insert

Bekijk gratis de handleiding van Structural Concepts Fusion GJDSS6RLB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.