Structural Concepts Fusion GJDSS12RLB handleiding

Niet gecategoriseerd

Structural Concepts

25 pagina's

PDF beschikbaar

Handleiding

CONDITION TROUBLESHOOTING

Case Lights Are Not

Working

Check that light switch is in the on position.

Check that ALL of the light cords and plugs are properly connected. See

INSTALLATION: DISPLAY CASE START-UP (START-UP / LIGHTS /

THERMOMETER / CONTROLLER) section in this operating manual.

Service Technicians Only: Check voltage at LED drivers. If voltage is entering but

not exiting, LED driver may be faulty.

Control Display Is

Flashing

See your case’s serial label for your model’s specified settings. See SERIAL

LABEL LOCATION & INFORMATION LISTED / TECH INFO & SERVICE for label

location, etc.

Case Is Not Holding

Temperature

If a large amount of warm product was added to the case, it will take time for the

temperature to adjust. Unit needs product to be pre-chilled.

Temperature changes during defrost mode but will return to normal. Fourth LED

will indicate defrost cycle in progress.

Check that case is not in sun or near a heat or air-conditioning vent. See

OVERVIEW / TYPE 1 vs. 2 / COMPLIANCE / WARNINGS / PRECAUTIONS /

WIRING / PLUGS section in manual for adverse conditions/spacing issue

parameters.

If case is located near front doors, temperature fluctuation can hinder unit’s ability

to maintain temperature. See OVERVIEW / TYPE 1 vs. 2 / COMPLIANCE /

WARNINGS / PRECAUTIONS / WIRING / PLUGS section in manual for adverse

conditions/spacing issue parameters.

Check air return grilles for obstructions.

TROUBLESHOOTING (TO BE PERFORMED BY TRAINED SERVICE PROVIDERS ONLY) - PAGE 2 of 2

Bekijk gratis de handleiding van Structural Concepts Fusion GJDSS12RLB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.