Structural Concepts Fusion GHSS856HLB handleiding

Niet gecategoriseerd

Structural Concepts

23 pagina's

PDF beschikbaar

Handleiding

START-UP & OPERATION - MODEL GHSS456HLB (REAR ACCESS) - AUTHORIZED PERSONNEL ONLY!

Vapor

Thermometer

Deck

Shelf 1

Shelf 2

Shelf 3

OFF

1. Start-Up - Note: This Section Is For

Authorized Personnel Only!

• Control panel is at case rear. It may be fully

accessible or accessed by removing rear panel

(no screw removal required).

• Main power switch, lights switch and

thermostats are on control panel. Replace rear

panel after energizing control panel

• Turn main power switch on to energize case

(heated deck, heated shelves and lights).

• Turn on light switch for case lights to come on.

• Caution! Deck, shelving and overhead lights are

HOT! Do not touch until case has been turned

off and allowed to cool for 45 minutes!

2. Pre-Cooking Food / Checking Food

Temperature

• Caution! Food MUST BE cooked PRIOR to

being placed in the case. Food should be

heated to between 150 °F to 160 °F (65.6 °C -

71 °C) prior to placing it in the case.

• All food products temps are to be at 140 °F to

165 °F (60 °C to 74 °C), for shelves and deck.

Food temperature must NOT be allowed to

be below FDA guidelines of 140 °F (60 °C).

• Use ONLY food probe to check product

temperature before placing it in case.

• DO NOT rely on case thermometer or infrared

thermometer gun!

• After product has been placed in case, check

product temperature (again) after one hour to

verify that proper food temperatures are

maintained.

3. Thermostat Settings

• Important! Default thermostat settings are

set at the factory. This case should rarely

require adjustments to thermostat settings.

• If thermostat settings need to be adjusted, see

PROGRAMMABLE CONTROLLER section in

this User Manual.

• If temperature is adjusted, allow 20 minutes at

NEW settings to determine if product

temperatures are acceptable.

• Check food temperature again after one hour.

4. Operating Tips

• When restocking, place new product at back and

rotate older product to front of case.

• Display product expected to sell within 4 hrs.

• Clean up residue immediately. Case will cause

spills and debris to harden to surface!

5. Shutting Down Case

• Remove all product from case.

• Turn main power switch to “OFF” position.

• Allow case to cool for 45 minutes before cleaning.

• See CLEANING SCHEDULE section in User

Manual for specific cleaning instructions.

6. Optional 4-Shelf Unit

• Case is wired for 4th shelf.

• Both receptacle and plug protective covers may

be removed by accessing two (2) screws.

Bekijk gratis de handleiding van Structural Concepts Fusion GHSS856HLB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.