Structural Concepts Fusion GHSS460H-4 handleiding

Niet gecategoriseerd

Structural Concepts

23 pagina's

PDF beschikbaar

Handleiding

START-UP & OPERATION - MODEL GHSS460H / GHSS656HLB - AUTHORIZED PERSONNEL ONLY!

Deck

Shelf 3

Shelf 1

Shelf 2

Remove For Optional Fourth

Shelf (Not Applicable To

Model GHSS656HLB)

Vapor

Thermometer

4. Operating Tips

• When restocking, place new product at back and

rotate older product to front of case.

• Display product expected to sell within 4 hrs.

• Clean up residue immediately. Case will cause

spills and debris to harden to surface!

5. Shutting Down Case

• Remove all product from case.

• Turn main power switch to “OFF” position.

• Allow case to cool for 45 minutes before cleaning.

• See CLEANING SCHEDULE section in User

Manual for specific cleaning instructions.

6. Optional 4-Shelf Unit

• Case is wired for 4th shelf.

• Both receptacle and plug protective covers may

be removed by accessing two (2) screws.

1. Start-Up - Note: This Section Is For

Authorized Personnel Only!

• Control panel is at case front. It may be

accessed by removing front panel (no screw

removal required).

• Main power switch, lights switch and

thermostats are on control panel. Replace front

panel after energizing control panel

• Turn main power switch on to energize case

(heated deck, heated shelves and lights).

• Turn on light switch for case lights to come on.

• Caution! Deck, shelving and overhead lights

are HOT! Do not touch until case has been

turned off and allowed to cool for 45 minutes!

2. Pre-Cooking Food / Checking Food

Temperature

• Caution! Food MUST BE cooked PRIOR to

being placed in the case. Food should be

heated to between 150 °F to 160 °F (65.6 °C -

71 °C) prior to placing it in the case.

• All food products temps are to be at 140 °F to

165 °F (60 °C to 74 °C), for shelves and deck.

Food temperature must NOT be allowed to

be below FDA guidelines of 140 °F (60 °C).

• Use ONLY food probe to check product

temperature before placing it in case.

• DO NOT rely on case thermometer or infrared

thermometer gun!

• After product has been placed in case, check

product temperature (again) after one hour to

verify that proper food temperatures are

maintained.

3. Thermostat Settings

• Important! Default thermostat settings are

set at the factory. This case should rarely

require adjustments to thermostat settings.

• If thermostat settings need to be adjusted, see

PROGRAMMABLE CONTROLLER section in

this User Manual.

• If temperature is adjusted, allow 20 minutes

at NEW settings to determine if product

temperatures are acceptable.

• Check food temperature again after one hour.

OFF

Bekijk gratis de handleiding van Structural Concepts Fusion GHSS460H-4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.