Structural Concepts Fusion GHSS452HLB handleiding

Niet gecategoriseerd

Structural Concepts

23 pagina's

PDF beschikbaar

Handleiding

INSTALLATION: SKID REMOVAL / FRAME SUPPORT RAIL SHIMMING / LEVELER ADJUSTMENTS

1. Remove Unit From Skid

• Caution: Case must always remain supported or

center of gravity will allow case to fall.

• Slide unit to rear of skid and lean backward off skid.

• Slide skid out from under case while case is being

supported.

Pry Bar

Toe-Kick

Base

Frame

Leveler

Adjustable

Wrench

3. Adjust Levelers

• Some cases have levelers. If so, after case

is in proper position, adjust case so it is

level and plumb (see illustration below).

• You may need to remove front and/or rear

Toe-Kick to access levelers.

• Use adjustable wrench to adjust leveler.

• Depending upon case weight it may be

necessary to use a pry bar to accomplish

this task.

• Do not use pry bar on toe-kick as it may

buckle.

• Do not use pry bar on end panel as it may

chip.

• Use pry bar ONLY on base frame to avoid

damaging case.

• See illustration and photo below.

2. Frame Support Rails Must Be Shimmed

• Most cases have frame support rails (shown below).

• Shims will be provided with all cases that have frame

support rails. Use shims to level case.

• You may need to remove front and/or rear toe-kick to

access levelers

• Note: After case is in position, it must be sealed to

floor to prevent entry or leakage of liquid or

moisture.

Frame Support

Rails

Bekijk gratis de handleiding van Structural Concepts Fusion GHSS452HLB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.