Structural Concepts Fusion GHS656R handleiding

Niet gecategoriseerd

Structural Concepts

32 pagina's

PDF beschikbaar

Handleiding

Fusion® User Manual 8Fusion® User Manual 8

Installation: Start Up

Plug Case In/Turn On Main Power Switch:

• Do not use an extension cord with this case.

• Do not operate this equipment with a damaged cord,

plug, or outlet.

• Ensure that the main power switch is off.

• Route the power cord through the appropriate knockout

in the rear panel. Install the supplied cord bushing in the

knockout hole. Do not install cord without bushing.

• Plug the cord into a certied 120V electrical outlet with

ground.

• Turn the main power switch on.

• Coil fans should turn on.

• From inside of the case, check for discharge air from

front bafe, to conrm that the fans are functioning

properly.

• When the case is in a start-up mode or has been idle for

a long period of time, the case may require 75 minutes

running time to pull down the temperature.

• Turn lights on.

• Light switch is located on the ceiling of merchandising

area.

• The lights should come on at the same time.

• Always maintain front and rear airow clearance of four

inches.

• Obstruction or restriction of air can void warranty.

• Note: Case temperature setting is determined by case

size. Temperature is controlled by a thermostat.

Light Switch

Main Power Switch

Bekijk gratis de handleiding van Structural Concepts Fusion GHS656R, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.