Structural Concepts Elevate BD3632IS handleiding

Niet gecategoriseerd

Structural Concepts

28 pagina's

PDF beschikbaar

Handleiding

OVERVIEW

• These Structural Concepts merchandisers are designed

to merchandise packaged products at 41 °F (5 °C) or

less product temperatures.

• Cases should be installed and operated according to this

operating manual’s instructions to ensure proper

performance. Improper use will void warranty.

• Component parts shall be replaced with like components.

NSF/ANSI TYPE II ENVIRONMENTAL CONDITIONS

• This unit is designed for the display of products in

ambient indoor store conditions where temperature and

humidity are maintained within a specific range.

•

NSF/ANSI Type II Conditions: Product is displayed in

store conditions with maximum ambient temperature of

80 °F (27 °C) and maximum relative humidity of 55%.

COMPLIANCE

• Performance issues when in violation of applicable NEC,

federal, state and local electrical and plumbing codes are not

covered by warranty. See below.

WARNINGS/DANGER

• This sheet contains important warnings to prevent injury or

death. Please read carefully!

REFRIGERANT DISCLOSURE STATEMENT

• This equipment is prohibited from use in California with any

refrigerants on the “List of Prohibited Substances” for that

specific end-use, in accordance with California Code of

Regulations, title 17, section 95374.

• This disclosure statement has been reviewed and approved

by Structural Concepts and Structural Concepts attests, under

penalty of perjury, that these statements are true & accurate.

WARNING: Hazardous moving parts. Do not operate unit with covers

removed. Fan blades may be exposed when deck panel is removed.

Disconnect power before removing deck panel.

WARNING

Risk of electric shock. Disconnect power before servicing unit.

CAUTION! More than one source of electrical supply is

employed with units that have separate circuits.

Disconnect ALL ELECTRICAL SOURCES before servicing.

WARNING

Condensate Pan is Hot!

Disconnect and allow to cool before cleaning or removing from case.

WARNING

ELECTRICAL

HAZARD

WARNING

KEEP

HANDS

CLEAR

HOT

SURFACE

WARNING

COMPLIANCE

This equipment MUST be installed in compliance with all applicable NEC,

federal, state and local electrical and plumbing codes.

OVERVIEW / TYPE / COMPLIANCE / WARNINGS / PRECAUTIONS / WIRING / PLUGS - PAGE 1 of 2

ATTENTION

CONTRACTORS

WARNING: This product can expose you to chemicals, including

Urethane (Ethyl Carbamate), which are known to the state of

California to cause cancer and birth defects or other reproductive

harm. For more information go to P65Warnings.ca.gov.

DANGER

Risk of fire or explosion. Flammable refrigerant is used in this case.

Consult repair manual/owner’s guide before servicing this product.

To minimize risk of possible ignition due to incorrect parts or improper service,

this case is ONLY to be serviced by factory authorized service personnel.

The flammable refrigerant type specified on case nameplate is on serial label.

This case’s R290 refrigerant lower flammability limit (LFL) is .038 (114kg/m³).

Bekijk gratis de handleiding van Structural Concepts Elevate BD3632IS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.