Structural Concepts Blend NM7255HSSV handleiding

Niet gecategoriseerd

Structural Concepts

33 pagina's

PDF beschikbaar

Handleiding

INSTALLATION, CONT’D.: CASTER ADJUSTMENT / LOCK / UNLOCK / CASE REMOVAL FROM SKID

2. Caster Height: Raising and Lowering

• Raise or lower casters (to adjust case height) by

rotating casters’ vertical adjustment rings.

• Rotate vertical adjustment ring clockwise to lower

caster (and increase height of case).

• Rotate vertical adjustment ring counter-clockwise

to raise caster (and decrease height of case).

3. Caster Rolling Capability: Unlocking

• Important! Case is shipped with caster mechanisms

factory set at ON (locked) to prevent case from

rolling.

• Unlock casters by pressing OFF on the caster

mechanism.

• See illustration at right.

4. Carefully Remove Case From Skid

• Check that casters are lowered as far down as they

will go (as instructed in step #4).

• Use handles to carefully slide case to rear of Skid

(see illustration at right).

• Caution! 4 people may be required for this task!

• Carefully lower to floor (using ramp if available).

• Slide Skid from under case as required.

• Maintain support of case at all times or center

of gravity may cause case to fall.

• NM7255HSSV (shown at right) may not reflect every

feature or option of your particular case.

5. Casters: Locking

• After case is at desired position (and height),

use level to check that case is level and plumb.

• Readjust height as needed (as instructed in

step #4).

• Locking Height: After proper height (and positioning) of

case is attained, tighten the two (2) set screws to lock

each caster’s height in place.

• Locking Movement: Then, to prevent casters’ rolling

capability, lock casters by pressing ON atop the “ON”

and “OFF” lever mechanism (shown at right). Case

will now be secured at its new location.

Vertical

Adjustment

Ring

Caster

Tighten Set

Screws To

Lock Caster

Height In

Place

Press “ON” Lever To

Lock Caster In Place

(And Prevent Casters’

Rolling Capability)

Skid

Support

case while

removing

from Skid

Press “OFF” Lever To

Unlock Casters (And

Allow Casters To Roll)

Caster

Ramp

Bekijk gratis de handleiding van Structural Concepts Blend NM7255HSSV, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.