Structural Concepts Blend NM7255DSSV handleiding

Niet gecategoriseerd

Structural Concepts

18 pagina's

PDF beschikbaar

Handleiding

INSTALLATION: TOE-KICK & REAR PANEL REMOVAL / REMOVING SKID BRACKETS AND BLOCKS

1. Remove Toe-Kicks

• To prevent damage to case, front

and side toe-kick should NOT be

on case at shipment.

• If they are, you must remove toe-

kicks from case before removing

case from skid.

• Toe-kicks are held in place by

magnets only.

• Place toe-kicks in secure locations

while removing case from skid.

• After case has been rolled into

location, adjusted and locked in

place, toe-kicks may be returned to

case.

• Note: Illustration at right is shown

without skid shown for illustrative

purposes.

2. Removing Skid Brackets and Blocks

• Use Phillips driver to remove screws from

shipping brackets. Remove and discard

shipping brackets from skid.

• Place J-bar/pry bar under base frame.

Raise case up from skid to take weight off

casters.

• With case raised, lower casters all the

way down against skid (see next step for

detailed instructions on lowering or

raising casters).

• Remove rubber shipping blocks.

J-Bar

Pry Bar

Shipping Bracket

Rubber Shipping

Block

Skid

Side

Toe-Kick

Side Toe-Kick

Front

Toe-Kick

Illustrations Shown Reflects Model

NM7255DSSV. It May Not Exactly

Reflect Every Feature or Option of

Your Particular Merchandiser.

Bekijk gratis de handleiding van Structural Concepts Blend NM7255DSSV, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.