Handleiding
Je bekijkt pagina 27 van 28
25
Problem Possible cause and solution
Snowy dots, blocking and interference If the antenna is located in the fringe area of a television signal where the signal
is weak, the picture may be marred by dots, show blocking or break-ups. When
the signal is extremely weak, it may be necessary to install a special antenna to
improve the reception.
1. Adjust the position and orientation of the indoor/outdoor antenna.
2. Check the connection of the antenna.
3. Fine tune the channel.
4. Try another channel. Broadcasting failure may happen.
Ghost Ghosts are caused by the television signal following two paths. One is the direct
path, the other is reected from tall buildings, hills, or other objects. Changing the
direction or position of the antenna may improve the reception.
Radio frequency interference This interference produces moving ripples or diagonal streaks, and in some case,
loss of contrast in the picture. Find out and remove the radio interference source.
Playback of video is causing picture
freeze/macro blocks or similar distortion,
especially on HD content
Read/write speed of your USB device could be too low. Make sure to use a USB
storage device with sucient speed and space. Pen drives (USB sticks) may not
support sucient speed.
Bad picture / blocking error during heavy
rain
Heavy rain will attenuate satellite signals, below a certain level blocking will occur.
Make sure your dish installation is up to standards to minimize rain eects. When in
doubt, ask a local satellite specialist for advice.
If the TV turns o after plugging a cable
into any connector
Again, turn on the TV.
No signal or weak signal, intermittent
reception
a) Cables might have loosened; moisture might have entered into cables or
connectors, heavy rain at present or heavy storm at present. Check the cable
connections, LNB and other equipment connected between the LNB and the
receiver, or peak the dish. Wait for rain/storm to subside. Ask a local satellite
specialist for advice.
b) The satellite dish is not pointing at the (correct) satellite(s). Adjust the dish. Ask a
local satellite specialist for advice.
c) Satellite dish is too small, trees or buildings in path. Change to a larger dish or
change position of dish.
d) Signal is too strong, dish is oversized. Connect a signal attenuator to the LNB
input. Ask a local satellite specialist for advice.
NOTE: If the problem persists after these solutions, please contact your local support centre or send a
support mail via our website www.strong-eu.com.
Bekijk gratis de handleiding van Strong SRT50UG7773C, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Strong |
| Model | SRT50UG7773C |
| Categorie | Televisie |
| Taal | Nederlands |
| Grootte | 3492 MB |