Stihl SEA 20.0 handleiding
Handleiding
Je bekijkt pagina 27 van 240
4.12 Cleaning, Maintenance and
Repair
WARNING
■
The hand vacuum may start up unintentionally
if the battery is left in place during cleaning,
maintenance or repair operations. This may
result in serious injury to people and damage
to property.
► Remove the battery.
■ Sharp cleaning agents, cleaning with a water
jet or pointed objects can damage the hand
vacuum, the battery and the charger. If the
hand vacuum, the battery or the charger is not
cleaned correctly, components may no longer
function properly or safety devices may be
rendered inoperative. They may cause serious
injury to persons.
► Clean the hand vacuum, battery and
charger as described in this instruction
manual.
■
If the hand vacuum, the battery or the charger
are not serviced or repaired correctly, compo‐
nents may no longer function properly or
safety devices may be rendered inoperative.
This may result in serous or fatal injury to peo‐
ple.
►
Do not attempt to service or repair the hand
vacuum, battery or charger.
► If the hand vacuum, the battery or the
charger require servicing or repairs: Con‐
tact a STIHL servicing dealer for assis‐
tance.
5 Preparing the hand vac‐
uum for Operation
5.1 Preparing the hand vacuum for
operation
The following steps must be performed before
commencing work:
► Ensure that the following components are in a
safe condition:
–
Hand vacuum, 4.6.1.
–
Battery, 4.6.2
–
Charger, 4.6.3.
►
Check the battery,
10.2.
►
Fully charge the battery, 6.2.
►
Cleaning the hand vacuum, 15.1
►
Check the controls, 10.1.
► If you cannot carry out these steps: Do not use
the hand vacuum and instead contact a STIHL
authorized dealer.
6 Charging the Battery, LEDs
6.1 Mounting the charger on a wall
The charger can be mounted on a wall.
a
0000-GXX-4349-A0
1
2 3
a
b
d
e
e
0000-GXX-8802-A0
► Check the following points when mounting the
charger on a wall:
–
Suitable fixing materials.
–
The charger is level.
The following dimensions are observed:
–
a = at least 100 mm
–
b (for AL 1 and AL 5) = 54 mm
–
b (for AL 5-2) = 100 mm
–
c = 4.5 mm
–
d = 9 mm
–
e = 2.5 mm
6.2 Charging the Battery
The charging time depends on various factors,
e.g. the battery temperature or the ambient tem‐
perature. For optimum performance, note the
recommended temperature ranges,
18.6. The
actual charging time may vary from the charging
time indicated. The charging time is indicated at
www.stihl.com/charging-times.
The charging process starts automatically when
the mains plug is plugged into a socket and the
battery is inserted into the charger. The charger
switches off automatically when the battery is
fully charged.
The battery and the charger warm up during
charging.
2
0000-GXX-8803-A0
3
4
5
6
1
5 Preparing the hand vacuum for Operation English
0458-006-9821-B 27
Bekijk gratis de handleiding van Stihl SEA 20.0, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Stihl |
| Model | SEA 20.0 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 27562 MB |
