Sthor 78985 handleiding

Niet gecategoriseerd

Sthor

40 pagina's

PDF beschikbaar

Handleiding

However, it is recommended to discharge them during normal work, and then load them to their full capacity. If due to the nature of the task it is not possible to do

so each time, then it is required to do it at least from time to time. Under no circumstances is it allowed to discharge the batteries short-circuiting the electrodes,

since this would cause irreversible damage! It is also prohibited to check the load of the batteries, short-circuiting the electrodes for sparking.

Storage of the battery

In order to prolong the life of the battery, it is required to provide adequate storage conditions. The batteries can go through approximately 500 „loading -

discharging” cycles. The battery must be stored between 0 and 30°C, at the relative humidity of 50%. In order to store the battery for a prolonged period, it is

required to charge it to approximately 70% of its capacity. In case of prolonged storage, it is required to recharge the battery once a year. Do not permit excessive

discharging of the battery, since this would reduce its life and may cause irreversible damage.

During storage, the battery will be gradually unloading due to leakage conductance. The process of automatic unloading depends on the temperature of storage,

since the higher the temperature, the fastest the process. In case of incorrect storage of batteries, there is a danger of electrolyte leakage. In case of leakage, it is

required protect the leakage with neutralizing agent. In case of contact of electrolyte with the eyes, it is required to rinse the eyes abundantly, and then immediately

seek medical assistance. It is prohibited to use a tool with a damaged battery.

In case the battery is completely worn out, it is required to deposit it at a special point dedicated to disposal of such waste.

Transport of the batteries

Lithium-ion batteries are in accordance with legal regulations treated as dangerous waste. The user of the tool may transport the tool with the battery or only

batteries by land. Then no additional conditions must be complied with. In transport is realised by third parties (for example dispatch through courier service), then

it is required to proceed in accordance with regulations for transport of dangerous materials. Before shipment, contact an authorised person.

It is prohibited to transport damaged batteries. During transport the battery must be removed from the tool, and the exposed contacts protected, e.g. with insulating

tape. Protect the batteries so that they do not move inside the package during transport. It is also required comply with the national regulations for transport of

dangerous materials.

Charging of the batteries

Attention! Before loading, it is required to disconnect the charger charging dock from the mains removing the plug of the charger from the mains socket.

Furthermore, it is required to clean the battery and its contacts, removing dirt and dust with a soft and dry cloth.

Disconnect the battery from the tool.

Connect the plug of the charger to the battery socket (I).

Connect the charger to the mains socket.

The diode of the battery will go on, which indicates the beginning of the loading process.

Once the loading process has finished, the diode will turn from red to green light.

OPERATING INSTRUCTION

Bekijk gratis de handleiding van Sthor 78985, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.