Steinberg SBS-TWB-100 handleiding
Handleiding
Je bekijkt pagina 7 van 66
EN
• “PV” – temperature display
• “SV” – timer display
• “RUN/AT” – working status light indicator (when working the indicator is lighting; during auto tuning,
the light indicator is flashing)
• “OUT” – heating light indicator (it is lighting when the device is heating)
• “ALM” – overtemperature alarm indicator (it lights when the temperature is too high)
• “SW” – low water warning level indicator (it lights when the water level is low)
Operation
1) When the device is being switched on, display shows the version number and the temperature range
value for 3 seconds, then it starts running.
2) “◄” button: In the setting state, click this button to shift the set value.
3) “▼” button: In the setting state, click the button to decrease the set value. If this button is pressed
and hold, the value will decrease continuously.
4) ”▲” button: In the setting status, click the button to increase the set value. If this button is pressed
and hold, the value will increase continuously.
5) In setting mode, If no button is being pressed within 60 seconds, than the device will automatically
return to normal operation state.
6) Temperature and time setting
a) Timer function off:
• Press the “SET” button in the non-set state, display shows the prompt “SP” and set
temperature value.
• Using the “SHIFT”、”DEC” and “INC” buttons, user can modify the settings to the desired
value, then pressing the “SET” button again and the device will return to the normal display -
the set value will be saved automatically.
b) Timer function on:
• Press the “SET” button in the non-set state, display shows the prompt “SP” and set
temperature value. Pressing the “SET” button again, display shows the prompt “ST” and set
time value.
• Press the “SET” button again and the device will return to the normal display, the setting
value will be saved automatically.
c) When the set time is “0”, it means that the timer is deactivated and the device will run
continuously. If the time is set, the lower display will show the set
temperature value or the
running time 2. When displayed the running time, the unit decimal point is lit – starts counting
down when the measured temperature reaches the set value, When the runtime is over, the
lower display shows “End” and the buzzer will sound for 60 seconds (it can be muted by pressing
any button). Press the “RST” button for 3 seconds at this time and the device will restart.
d) When over-temperature alarm triggers, the buzzer beeps continuously and the "ALM" warning
indicator light is lit. When the buzzer sounds, press any key to mute.
Bekijk gratis de handleiding van Steinberg SBS-TWB-100, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Steinberg |
| Model | SBS-TWB-100 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8960 MB |
