Steinberg Padshop 2 handleiding
Handleiding
Je bekijkt pagina 9 van 58
4. Set Loop to Off.
5. Adjust the Purity and Inharmonicity parameters.
Purity affects the brightness of the sound, and Inharmonicity changes the timbre from
clean to dissonant.
6. Set Purity to +50 % and Inharmonicity to 0 %.
7. In the modulation matrix, assign Velocity to Spectral Purity and set the modulation Depth
to -25 %.
8. Assign Velocity to Spectral Inharmonicity and set the modulation Depth to +25 %.
The higher the velocity of the note, the brighter and more inharmonic the sound. Now, the
sound is too dull when playing low notes and too bright when playing high notes.
9.
Set Formant Key Follow to 0 % to correct this with the formant lter.
10.
To make the sound more playable, set Amplier Velocity to +50 %.
11.
Optional: Add lters, amplier envelope, effects, or an arpeggio.
12.
Optional: Experiment with other samples and the settings you made for this sound.
TIP
The “Illusions of Piano” preset is a good example of a preset that was produced this way.
Common Editing Methods
Some common controls and concepts exist throughout the program. For example, presets can
be used in several different sections and contexts, but their handling is always the same.
Knobs and Sliders
Knobs and sliders can be unidirectional or bidirectional. Unidirectional values, for example, level
values, start at a minimum value and go up to the maximum. Bidirectional controls start from the
middle position and go to the left for negative and to the right for positive values.
Most of the editing methods are the same for knobs and sliders.
● Move the mouse over a knob or its parameter name to show the current parameter value.
You can adjust the value with the mouse wheel or enter a new value manually.
● To adjust a value, click a knob or a slider and drag up and down, or use the mouse wheel.
If you press Alt/Opt when clicking a knob, a small slider appears, allowing you to set the
parameter.
●
To make ne adjustments, press Shift , and move the knob or use the mouse wheel.
●
To restore the default value for a parameter, press Ctrl/Cmd , and click on the control.
Buttons
Padshop contains two different types of buttons: On/Off buttons and push buttons.
On/Off Buttons
These buttons have two states: on and off. If you move the mouse over an On/Off button, it
changes its appearance to show that you can click it.
Padshop
Common Editing Methods
9
Padshop 2.2.0
Bekijk gratis de handleiding van Steinberg Padshop 2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Steinberg |
| Model | Padshop 2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9568 MB |
