Standard Horizon Matrix GX2200 Handleiding (152 Pagina's)

Handleiding

Page15GX2200

6.3.2 Optional MMB-84 Flush Mount Bracket

1. Use thesuppliedtemplate to markthelocation wheretherectangular

hole is to be cut. Conrm the space behind the dash or panel is deep

enoughtoaccommodatethetransceiver(atleast6.7”(17cm)deep).

 Thereshouldbeatleast1/2”(1.3cm)betweenthetransceiver’sheatsink

andanywiring,cablesorstructures.

2. Cutouttherectangularholeandinsertthetransceiver.

3. Fastenthebracketstothesidesofthetransceiverwiththelockwasher

screwcombination;sothatthemountingscrewbasefacesthemounting

surface(seeillustrationbelow).

4. Turntheadjustingscrewtoadjustthetensionsothatthetransceiveris

tightagainstthemountingsurface.

Bracket

Lock-washerscrewcombination

AdjustingScrew

NOTE

AGPSreceiverandantenna of the GX2200 is located in the front

panel.Inmanycasestheradiomaybeflushmounted,however

before cutting holes to ush mount the radio it is recommended to

temporarily connect the radio to power and turn on in the location

whereitwillbeushmountedtoconrmitisabletoreceiveaGPS

locationonit’sdisplay.Iftheradioisnotabletoreceivealocation,a

GPSChartplotterwithNMEA0183outputortheoptionalStandard

HorizonexternalGPSantennamaybeneededtoreceiveGPSsatel-

litesignals.

TousetheoptionalStandardHorizonexternalGPSantenna

(Q7000619A),theGX2200internalGPSUnitPowermustbeturned

OFF(refertosection“15.1 UNIT POWER”)andtheGPSSelection

changed to External GPS (refer tosection“15.9 POSITION DATA

PRIORITY”).

Bekijk gratis de handleiding van Standard Horizon Matrix GX2200, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.