Stamos PROLOX 45VO handleiding
Handleiding
Je bekijkt pagina 13 van 111
EN
Trouble shooting for PROLOX45VO, PROLOX55VO
Faults
Resolvable Methods
1.Switch indicator is on; fan is not
working, and control knob is out of work.
1.Over voltage protection is working. Close machine
then opens it again after several minutes.
2.Switch indicator is lit and fan is
working. However, press control knob of
torch, there is no HF arc-striking sound
and electromagnetic valve is not working.
1. Check if torch is open circuit.
2. Check if control knob of torch is damaged.
3. Part of assistant power of top board is damaged and
there is no DC 24v output.
3.Switch indicator is lit and fan is
working. However, press control knob of
torch, there is no HF arc-striking sound
and inter red diode is lit.
1. Check if MOS K1170 of top board is damaged
(driver mold is damaged).
2. Rising transformer of bottom board is damaged.
3. Control mold is damaged.
4. Switch indicator is lit and fan and
electromagnetic valve are working.
However, there is no sound of HF arc-
striking and inter red diode is not lit .
There is some trouble in part of arc-striking, such as:
1. It is too far between discharge tip or there is
adhesion in discharge tip.
2. Primary coil of arc-striking transformer is damaged
or poor contact.
3. Check if four times voltage rectifier diode is
stricken.
4. Check if HF electric capacity 102/10KV is leaking.
Relay is damaged.
5.Other of machine is normal, but arc is
not stricken when it is be operating.
1. Input voltage is too low.
2. Pressure of air compressor is too high or too low.
Bekijk gratis de handleiding van Stamos PROLOX 45VO, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Stamos |
| Model | PROLOX 45VO |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8492 MB |
