Stairville SonicPulse MH Wash 1208 handleiding

Verlichting

Stairville

44 pagina's

PDF beschikbaar

Handleiding

10 Troubleshooting

NOTICE!

Data transfer errors due to improper wiring!

If the DMX connections are wired incorrectly, this can cause errors

during the data transfer.

Do not connect the DMX input and output to audio devices, e.g. mixers

or ampliers.

Use special DMX cables for the wiring instead of normal microphone

cables.

In the following we list a few common problems that may occur during operation.

We give you some suggestions for easy troubleshooting:

Symptom Remedy

The device is not working, no

light

1. Check the mains connection.

2. Check the settings in manual mode.

No response to the DMX con‐

troller

1. Check whether the DMX controller is switched

on. Check that the DMX connections and cables

are connected properly.

2. Check the address settings and the DMX

polarity.

3. Check whether the DMX cables run near or par‐

allel to high-voltage cables that may cause

damage or interference to a DMX interface circuit.

4. Try using another DMX controller.

Unintended light eects Make sure that the DMX channel assignments of

the devices do not overlap, and that the DMX start

address of devices with independent control is

always higher by the number of channels that

have been set for the DMX mode on another

device.

If the procedures recommended above do not succeed, please contact our Service

Center. You can nd the contact information at www.thomann.de.

Troubleshooting

SonicPulse MH Wash 1208

Moving Head

Bekijk gratis de handleiding van Stairville SonicPulse MH Wash 1208, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.