Speed Queen TR5006WN handleiding
Handleiding
Je bekijkt pagina 24 van 26
Washer Symptom Possible Cause/Solution
WASH, RINSE STATUS lights on con-
tinuously
Drain Error
• This code indicates that water is still in the washer at the end of the cycle.
• Check the drain hose and drain receptacle to make sure they are installed properly
and not blocked.
• Unplug the machine for 15 seconds to clear this code.
WASH, RINSE STATUS lights flash 1
time
Pressure Sensor Error
• The control has detected trouble sensing the water fill level.
• Unplug the machine and call for service.
RINSE, LID LOCK STATUS lights flash
3 times
Lid Open Error
• The control senses that the lid is open during a running cycle.
• Unplug the machine to clear this code.
RINSE, LID LOCK STATUS lights flash
2 times
Lid Lock Error
• The control senses that the lid has unlocked during a running cycle.
• Unplug the machine to clear this code.
WASH, RINSE STATUS lights flash 2
times
No Water Flow Error
• The washer has not filled to the proper water level.
• No or very little change in water level has been sensed within 5 minutes of the cur-
rent fill.
• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Clean the screens in the water mixing valve and the filter screens located at the
faucet end of the fill hoses.
• Unplug the machine for 15 seconds to clear this code.
WASH, RINSE STATUS lights on con-
tinuously
Overflow Error
• This code indicates the washer has filled to the overflow level.
• The machine will begin to attempt to pump water out if the lid is closed and locked.
• If the code does not clear, unplug the machine and call for service.
RINSE, LID LOCK STATUS lights flash
3 times
Lid Unlocking Error
• The control senses that the lid will not unlock.
• Unplug the machine for three minutes to unlock the lid.
• If the code appears again, call for service.
RINSE, LID LOCK STATUS lights flash
2 times
Lid Locking Error
• This code indicates that the lid has not locked.
• Make sure the lid is closed all the way and try to start the cycle.
• Open the lid or unplug the machine to clear the code.
• If this code continues, call for service.
WASH, SPIN STATUS lights flash 2
times
Max Speed Not Reached Error
• This code indicates that the washer did not reach the maximum intended speed in
the final spin.
• This could be due to an unbalanced load, excessive suds in the load, or too much
water left in the tub due to slow draining.
• Be sure to use proper load sizes that are evenly distributed in the wash basket.
• Be sure to use high efficiency (HE) detergent.
• Open the lid or press the Start/Pause button to clear this code.
Table continues...
Troubleshooting
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
24 Part No. 205052ENR1
Bekijk gratis de handleiding van Speed Queen TR5006WN, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Speed Queen |
| Model | TR5006WN |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 2650 MB |
