Speed Queen SF7008WE handleiding
Handleiding
Je bekijkt pagina 12 van 21
time before or during the cycle. The time may need to be ad-
justed up if the items are still damp or down if the items are
overdry.
Steam
The Steam SanitizeSteam Sanitize cycle sanitizes your laundry by killing
99.9% of common household bacteria*. It is a 75-minute
cycle that applies high-temperature heat to sanitize the
load, as well as steam to help keep your laundry soft and
wrinkle free. It is recommended for medium size loads and
is not recommended for all fabric types. Be sure to follow
fabric care labels.
To use Steam Sanitize, press the Steam Sanitize keypad
and allow the cycle to complete uninterrupted. Time can be
extended higher than 75 minutes by using the up and down
arrow keypads.
NOTE:NOTE: The Sanitize setting uses high heat. Check the fabricThe Sanitize setting uses high heat. Check the fabric
label for proper care instructions.label for proper care instructions.
The Steam RefreshSteam Refresh cycle releases wrinkles and refreshes
your items. It is recommended for 1-4 items. There are two
preset cycles. The default cycle applies a medium-tempera-
ture heat for 30 minutes to the load. The alternate cycle ap-
plies a high-temperature heat for 20 minutes.
To use Steam Refresh, press the Steam Refresh keypad
and the default cycle for 30 minutes at medium heat will be
initiated. To initiate the 20-minute, high-heat cycle, toggle
the Temp selection to High. Select the 30-minute medium
heat or 20-minute high heat temperature based on fabric
type.
*Bacteria tested by an independent lab were Staphylococ-
cus aureus, Pseudomonas aeruginosa, Klebsiella pneumo-
niae. Individual results may vary.
IMPORTANT:IMPORTANT: Do not use dryer sheets when using steam cy-Do not use dryer sheets when using steam cy-
cles.cles.
IMPORTANT:IMPORTANT: Do not run steam with no load to help preventDo not run steam with no load to help prevent
water from staining the cylinder.water from staining the cylinder.
NOTE:NOTE: Do not overload machine for steam cycles. Overload-Do not overload machine for steam cycles. Overload-
ing during a steam cycle may cause the load to have weting during a steam cycle may cause the load to have wet
spots at the end of the cycle.spots at the end of the cycle.
NOTE:NOTE: Using steam on overly damp items may result in loadUsing steam on overly damp items may result in load
not completely drying.not completely drying.
Selections
The following selections can be used to modify the currently
chosen cycle. The default selections will be lit after choos-
ing a cycle.
Temp
Press the Temp keypad to change the cycle's temperature
on Manual Cycles, Pet Items, and Steam Refresh. Choose
from No Heat, Low, Medium, or High depending on fabric
type.
NOTE:NOTE: The No Heat cycle will take longer to dry items.The No Heat cycle will take longer to dry items.
Dryness
Press the Dryness keypad to change the dryness level in an
Auto-Sensing cycle. Choose from Damp, Less Dry, Near Dry
or Dry.
Use Damp to leave load slightly damp for easier ironing.
Use Less Dry for lightweight items such as sheets and
shirts.
Use Near Dry for normal loads.
Use Dry for heavy items such as blue jeans and blankets.
Over-drying can cause wrinkling, shrinking, excessive lint
conditions, and will use more energy than necessary. To in-
crease energy savings and to make sure loads are dried
without over-drying, set your Auto-Sensing loads on Near
Dry or Less Dry. If items are damp or over-dry at the end of
a cycle, increase or decrease the Dryness setting the next
time these loads are dried. Remember the settings that
work best to get ideal drying results. To finish drying damp
items, use Quick Dry and adjust the time as needed.
Options
The following options can be used to modify the currently
chosen cycle, adjust the signal volume, and save favorite cy-
cles.
Extended Tumble
The Extended Tumble option prevents wrinkling by tumbling
the clothes load after the end of the cycle every two min-
utes for up to 60 minutes. The display will show the time re-
maining. The Extended Tumble LED light will be lit during
the Extended Tumble portion of a cycle. The option will end
if the door is opened.
Extended Tumble can be used along with the Steam Boost
and Anti-Static options. Steam Boost runs first, followed by
Anti-Static and then Extended Tumble.
Steam Boost
Use to release wrinkles and soften fabrics. Available with
Auto-Sensing Heavy Duty, Regular, and Perm Press cycles
as well as Pet Items (Medium or High heat only). Dryness/
Auto-Dryness must be set to Near Dry or Dry. Cannot be
used with EcoDry.
Steam Boost can be used along with the Anti-Static option.
Steam Boost runs before Anti-Static.
Anti-Static
The Anti-Static option reduces static build-up by adding a
small amount of steam toward the end of the cycle. To use,
press the Anti-Static keypad. It is available with Heavy Duty,
Regular, Perm Press, Delicates, Pet Items, and Pet Hair Re-
mover cycles only. Dryness must be set to Near Dry or Dry
on Auto-Sensing cycles. Anti-Static can be used along with
the Steam Boost option. Steam Boost runs before Anti-Stat-
ic. It cannot be used with EcoDry.
Operating Your Dryer
© Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
12 Part No. D518908ENR3
Bekijk gratis de handleiding van Speed Queen SF7008WE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Speed Queen |
| Model | SF7008WE |
| Categorie | Wasdroger |
| Taal | Nederlands |
| Grootte | 1666 MB |
