Speed Queen SF7008BG handleiding
Handleiding
Je bekijkt pagina 16 van 21
Maintenance
Lubrication
All moving parts are sealed in a permanent supply of lubri-
cant or are equipped with oilless bearings. Additional lubri-
cation will not be necessary.
Care of Your Dryer
WARNING
To reduce the risk of an electric shock, serious
injury or death, disconnect the electrical service to
the dryer before cleaning the interior.
W132
Dryer Interior
Wipe the surfaces using a soft cloth and household cleaner
or a non-abrasive paste of powdered laundry detergent and
hot water, followed by a short heat cycle with a load of rags.
To remove crayon or ball point ink off the dryer drum, put
the heat on high and use old rags in the dryer to absorb the
crayon or ink. If unsuccessful, contact the appliance dealer.
DO NOT use any chemicals in the dryer.
IMPORTANT:IMPORTANT: The use of chlorine bleach for removing any dis-The use of chlorine bleach for removing any dis-
colorations should be avoided because bleach could dam-colorations should be avoided because bleach could dam-
age the finish.age the finish.
Cabinet
Wipe the dryer cabinet as needed. If detergent, bleach or
other washing products have been spilled on the dryer, wipe
immediately. Some products will cause permanent damage
if spilled on the cabinet.
Control Panel
Use only a damp or sudsy cloth for cleaning the control pan-
el. Some spray pretreat products may harm the finish on the
control panel. DO NOT use products that contain alcohol on
the control panel.
Exhaust System
WARNING
To reduce the risk of electric shock, disconnect the
electrical service to the dryer before cleaning.
W043
WARNING
Any disassembly requiring the use of tools must be
performed by a suitably qualified service person.
W299
The exhaust duct should be inspected after one year of use
and cleaned if necessary by a qualified service person to re-
move any lint build-up. Inspect and clean exhaust duct
every one to two years as required thereafter.
Every two years a qualified service person should remove all
front panels and vacuum the inside of the dryer
NOTE:NOTE: This recommended maintenance is not covered underThis recommended maintenance is not covered under
the terms of the warranty.the terms of the warranty.
The weather hood should be checked frequently to make
sure the dampers move freely, dampers are not pushed in
and that nothing has been set against them.
Keep dryer area clear and free from combustible materials,
gasoline and other flammable vapors and liquids.
Do not obstruct the flow of combustion and ventilation air.
NOTE:NOTE: Verify proper operation after servicing.Verify proper operation after servicing.
Motor Overload Protector
The dryer’s motor overload protector stops the motor auto-
matically in the event of an overload. The control’s digital
display will show “Er”, “ro” alternately. After cooling, the
overload protector will reset itself.
The control can be cleared by pressing START and the dryer
can be restarted by pressing START again. If overload pro-
tector cycles again, remove the dryer from use and call the
service person to correct the problem.
Lint Filter
The lint filter is located at the front of the dryer in the lower
part of the door opening.
CLEAN THE LINT FILTER BEFORE DRYING EACH LOAD. (If us-
ing optional lint filter guard, remove first).
Annually remove lint filter and screw to vacuum the duct un-
der it.
Maintenance
© Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
16 Part No. D518541ENR6
Bekijk gratis de handleiding van Speed Queen SF7008BG, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Speed Queen |
| Model | SF7008BG |
| Categorie | Wasdroger |
| Taal | Nederlands |
| Grootte | 1799 MB |
