Speed Queen FV6000WN handleiding
Handleiding
Je bekijkt pagina 13 van 119
Preliminary Information
About the Control
This control is an advanced, programmable computer that lets the
owner control most machine features by pressing a sequence of
keypads.
The control allows the owner to program custom cycles, set vend
prices, retrieve audit information, run diagnostic tests, program
special vend features and set other programmable features. Wash-
ers shipped from the factory have a default cycle setting of NOR-
MAL COLD built in. However, the owner can change the default
cycle, or any cycle, as needs permit.
IMPORTANT: In the event of a power failure, the control
will not have to be reprogrammed. It is designed with a
memory system that will remember how it was pro-
grammed until the electrical power is restored.
IMPORTANT: It is extremely important that the washer
has a good ground connection and that all mechanical
and electrical connections to the control are made be-
fore applying power to or operating the washer.
Glossary of Terms
The following are a few terms and abbreviations to learn. These
are referred to throughout the instructions.
Display – This term refers to the window area of the control that
displays words and values.
LED (Light Emitting Diode) – This term refers to the lights next
to the keypads and status words of the control.
FEC – Front End Control
I/O Board – Input/Output Board
OPL – On Premises Laundry
NFC – Near Field Communications
Power Failure Recovery
If a cycle is in progress and the power fails, the cycle status is
saved in memory. When the power recovers, the washer will re-
sume into the previously active cycle if so programmed by the
owner.
The owner may program a special feature called POWER FAIL
RESET which sets a maximum power failure duration. To pro-
gram this feature, refer to Programming Control.
If the length of the power failure is greater than the POWER
FAIL RESET time, the control will end the cycle and the display
will revert back to the ready mode.
On drain pump models, if the wash basket is full of water, the
control will lock the door and pump out the water.
Communications
The control may be programmed manually, by Near Field Com-
munication with an external device or by a network. A limited
number of features can be programmed by a card reader.
Near Field Communications
The Near Field Communications (NFC) feature allows the con-
trol to communicate with an external device. The control can be
programmed and have its data read without using the keypad. It
may also be used to start and stop various diagnostic tests.
Serial Card Reader Communications (Card Models
Only)
The control will accept communication with a serial card reader
in order to perform vending transactions when a card is inserted
to pay for cycles. The card reader can also allow the owner to
program a limited number of features and collect audit informa-
tion.
For detailed information on serial card reader communications,
refer to instructions included with card reader.
Network Communications
Network communications allow an owner to program, collect da-
ta and run diagnostics on any machine.
Preliminary Information
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
13 Part No. 807870ENR4
Bekijk gratis de handleiding van Speed Queen FV6000WN, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Speed Queen |
| Model | FV6000WN |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 14039 MB |
