Speed Queen FF7011WN handleiding
Handleiding
Je bekijkt pagina 10 van 13
Position and Level the Washer
WARNING
Washers elevated above floor level must be
anchored to that elevated surface, base or platform.
The material used to elevate the washer should also
be anchored to the floor to ensure that the washer
will not walk or that the washer can not be
physically pulled, tipped or slid from its installed
position. Failure to do so may result in conditions
which can produce serious injury, death and/or
property damage.
W306
1. Position unit so it has sufficient clearance for installation and
servicing.
NOTE: Use of the dispenser drawer or washer
door as a handle in the transportation of the wash-
er may cause damage to the dispenser or door.
2. Place unit in position on a solid, sturdy and level floor. In-
stalling the unit on any type of carpeting, soft tile or other
weakly supported structures is not recommended.
3. Place a level on the raised portion of cabinet top and check if
the unit is level from side to side and front to back.
4. If unit is not level, tilt unit to access the front and rear level-
ing legs. For easier access to leveling legs, prop up unit with
a wooden block.
5. Loosen 7/8 in. locknut and adjust legs by screwing into or
out of unit base until the unit is level from side to side and
front to back (using a level). Unit should not rock.
NOTE: Leveling legs can also be adjusted from in-
side the unit using an adjustable wrench.
6. Tighten the locknuts securely against the unit base. If the
locknuts are not tight, unit will move out of position during
operation.
NOTE: DO NOT slide unit across floor if the level-
ing legs have been extended. Legs and base could
become damaged.
7. Remove rubber feet from accessories bag and place on all
four leveling legs.
8. Verify that unit doesn’t rock.
1. Leveling Leg
2. Washer Base
3. Level
4. Wood Block
5. Locknut
6. Rubber Foot
Figure 11
Wipe Out Inside of Wash Drum
1. Prior to first wash, use an all purpose cleaner or a detergent
and water solution and a damp cloth to remove shipping dust
from inside of the washer.
Figure 12
Plug In the Washer
Electrical Requirements
120 Volt, 60 Hertz with 3-Prong Earth/Ground Plug
NOTE: The wiring diagram is located in the control
hood.
Installation
© Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
10 Part No. 806987ENR3
Bekijk gratis de handleiding van Speed Queen FF7011WN, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Speed Queen |
| Model | FF7011WN |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 1600 MB |
