SoundTube CM42-EZS-I handleiding
Handleiding
Je bekijkt pagina 3 van 4
2. Use included tile bridge to
mark cutout in sheetrock.
3. Use Rotozip or other tool to
cut hole.
12. Done!
1. Unpack speaker & set aside
grille assembly.
5. Tighten screw on terminal
plate, and push conduit
connector into knockout.
4. Run signal wires through
conduit connector, then through
cover plate. Connect to ceramic
terminal strip. Two + and two -
connectors are provided for
daisy chaining.
9. Select the tap position by
adjusting rotary switch
to desired high impedance
value or voice coil direct mode.
11. Press grille into place.
8. Once all painting and nish
work is completed, remove the
paint mask.
7. Insert speaker into mounting
hole with installation aid in
place. Screw down both bolts
on the bafe face to actuate the
mounting wings. Firmly secure
both bolts – do not
over-tighten.
6. If required, a sheet-metal tab
located on the rear panel of the
speaker serves as a secondary
point of attachment (cable not
included).
Hole Diameters:
CM42-EZs-II: 165.1 mm (6.50 in)
All other CMEZ, FS, & BGM models:
266.7 mm (10.50 in)
1.
2.
10. Attach grille safety clip by
placing the large end of the clip
over snap-t post (1), then
sliding clip until small end
snaps into place around post
(2).
1.855.663.5600
|
www.soundtube.com
Sheetrock Ceiling Install Instructions
CM-EZ / BGM Series
Bekijk gratis de handleiding van SoundTube CM42-EZS-I, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | SoundTube |
| Model | CM42-EZS-I |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 885 MB |
