SoundTube CM-EZ-II handleiding
Handleiding
Je bekijkt pagina 3 van 4
1.435.647.9555
|
800.647.TUBE
|
www.soundtube.com
Sheetrock Ceiling Install Instructions
CM-EZ-IICM-E
CM-E
Z-II
Z-II
CM-EZ-II
2. Using a screwdriver, push
release pin up to release
cam. Turn clockwise
until threads engage to
lock cam. Properly term-
inate signal wire in ceiling.
2. Cut hole in tile using key-
hole saw or Roto-Zip tool.
3. Set tap to proper setting.
CM-EZ-8 is factory preset
in the 70.7 Volt mode in
the 20 Watt setting.
4. Thread tap & signal wires
thru flexible conduit clamp.
Connect wires with wire
nuts. See tap settings on
front page of this manual
for proper settings.
5. Push connections and
terminated tap wires
into backcan. Push
flexible conduit clamp
into backcan and tighten
clamp onto conduit.
1. Using supplied template
or, tile bridge to mark
9 9/16" (243 mm) hole.
7. Done!6. Snap speaker into drywall
ceiling. If using optional
alignment ring, the snap
cams must clear the
alignment ring screw tabs.
To Uninstall Speaker
1. Remove grille and
locate brass release
pins (x4).
Bekijk gratis de handleiding van SoundTube CM-EZ-II, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | SoundTube |
| Model | CM-EZ-II |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 654 MB |
