Sony HKCU1003 handleiding
Handleiding
Je bekijkt pagina 50 van 66
50
Locations and Functions of Parts
HDCU1500 Rear Panel
a SDI1, SDI2, SDI3 (MON) connectors (BNC-type)
The signal from the video camera may be output as three
HD-SDI or SD-SDI signals. The SDI1 connector and the
SDI2 connector output the same format signal. The signal
output from the SDI3 (MON) connector can be
superimposed character and marker.
b REFERENCE connectors (BNC-type)
Input an HD tri-level reference sync signal or SD reference
sync signal (black burst signal) to either of the two
connectors.
The input signal is output from the other connector as is
(loop-through output). If loop-through output is not used,
terminate the unused connector at 75 ohms.
The type of reference signal is selected using the setup
menu, or using the MSU-900 series Master Setup Unit.
For details on the setup menu, contact a Sony service or
sales representative.
To use the VBS signal of the HKCU1001 SD Encoder Unit
or the HKCU1003 Multi Interface Unit (when SC phase
lock is required), use an SD reference sync signal (black
burst signal).
c CHARACTER connector (BNC-type)
Outputs the self-diagnostic results or the setup menu as an
SD monochrome analog video signal.
1 SDI1, SDI2, SDI3 (MON) connectors
2 REFERENCE connectors
3 CHARACTER/SYNC connector
4 PROMPTER connectors
6 MIC1, MIC2 connectors
7 CAMERA connector
8 Expansion slots
5 (LAN) connector
qf TRUNK A connector
qg AC IN connector
qd WF MODE connector
qs RCP/CNU connector
qa MIC REMOTE connector
0 RET1, RET2, RET3 connectors
9 INCOM/TALLY/PGM connector
Note
Bekijk gratis de handleiding van Sony HKCU1003, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sony |
| Model | HKCU1003 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 12915 MB |
