Sonnenkonig Windmaschine 23 handleiding
Handleiding
Je bekijkt pagina 44 van 48
EN
4444
05 - OPERATION
FOLLOW THESE INSTRUCIONS TO PERATE THE FLOOR FAN
1. Unpack Floor Fan from carton.
2. To use the unit, place the unit in the area most suitable for the application. Several factors need to be con-
sidered; the unit must be placed close enough to an AC outlet to be plugged in, there must be a minimum
clearance of two feet from either side of the unit to allow for proper air flow, and the unit should not be
placed where it can become a tripping or safety hazard.
3. Place unit in the proper operating position for the application. Refer to the operating positions section in
this manual.
4. To use multiple Floor Fans, refer to the multiple Floor Fan instructions in this section.
5. Plug unit into the wall.
6. Turn unit on and select air speed by turning the switch, located near the top handle, clockwise, then turn on
the timer knob on ON or OFF-3H.
7. When the drying job is completed, turn the unit off and follow the directions for storage in this manual.
8. This unit comes with receptacles for use with multiple units. To use this feature, position the first Floor Fan
following the instructions listed above in this section. This unit may be turned on while connecting multiple
units.
9. Use only on a level and stable surface to prevent the Floor Fan from falling and possibly causing injury or
damage to the unit.
10. Plug the second unit into one of the receptacles on the first unit. Place the second unit in the operation
position and the area most suitable for the application. The second unit may be turned on at this time.
11. A third unit may be plugged into the remaining receptacles on the first unit or plugged into one of the
12. receptacles in the second unit. The third unit maybe turned on at this time.
13. If desired, follow the same steps to add more units (no more than 6 units total, including the main unit).
14. The receptacles on the unit are equipped with a circuit protector that will shut off power to the unit should
the receptacles become overloaded. If this happens, move the switch to the off position on the unit and any
units connected to it. Press the reset button located above the receptacle; then turn the unit on and any
units connected to it.
NOTE: To reduce the risk of fire or electric shock, do not use this Floor Fan with any solid-state speed control
device.
Bekijk gratis de handleiding van Sonnenkonig Windmaschine 23, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sonnenkonig |
| Model | Windmaschine 23 |
| Categorie | Ventilator |
| Taal | Nederlands |
| Grootte | 4688 MB |
