Sonnenkonig Tronas 53 handleiding
Handleiding
Je bekijkt pagina 43 van 48
EN
43
05 - OPEARATING INSTRUCTIONS
UNPACKING & SET-UP SUMMARY
1. Pull lid latches in an outward motion, remove power head and some accessories that may have been shipped
in the tank.
2. Attach the casters according to the instruction in this manual.
3. Before replacing power head, refer to this manual to ensure you have the proper filters installed for your
cleaning operation.
4. Replace power head, and apply pressure with thumb to each latch until it snaps tightly in place. Make sure
all lid latches are clamped securely.
5. Insert the flexible hose end into inlet of tank.
6. Attach the extension wands to the accessory end of the hose. Apply slight pressure until fitting is tight.
7. Attach one of the cleaning accessories (depending on your cleaning requirements) on the extension wands.
Twist slightly to tighten the connection.
8. Plug the cord into the wall outlet. The vacuum is ready for use.
CASTER ASSEMBLY
• Invert dust tank, take the dolly to align the tank bottom sinking place. Secure with screws provided.
• Return dust tank assembly upright.
WARNING:
To reduce the risk of fire or explosion, do not operate this vacuum in areas with flammable
gases, vapors or explosive dust in the air. Flammable gases or vapors include but are not limited to:
lighter fluid, solvent-type cleaners, oil-based paints, gasoline, alcohol or aerosol sprays. Explosive
dusts include but are not limited to: coal, magnesium, aluminum, and grain or gun powder. Do not
vacuum explosive dust, flammable or combustible liquids or hot ashes. Do not use this vacuum as a
sprayer for any flammable or combustible liquid. To reduce the risk of health hazards from vapors or
dusts, do not vacuum toxic materials.
WARNING: The operation of any utility vacuum can result in foreign objects being blown into the eyes,
which can result in severe eye damage. Always wear safety eyewear.
CAUTION: To reduce risk of hearing damage, wear ear protectors when using the vacuum for extended
hours or when using it in a noisy area.
This vacuum is assembled at the factory and ready for use when you remove it from the carton. The
unit is ready for dry vacuuming or blowing. After you plug the power cord into the wall receptacle, turn
the unit “ON” by pushing the switch from position “O” to position “I”. The “O” is the “OFF” position and
the “I” is the “ON” position.
Bekijk gratis de handleiding van Sonnenkonig Tronas 53, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sonnenkonig |
| Model | Tronas 53 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6222 MB |
