Sonifex DHY-04 handleiding
Handleiding
Je bekijkt pagina 26 van 56
16
3 Connecting the DHY-04 TBU
can signal this to remote equipment and the DHY-04 supports the 3 most
common methods:
• Momentarily reversing the polarity of the signal (line reversal);
• Momentarily shorting the tip & ring (K-break)
• Issuing a tone to the line (tone detect).
The method chosen is initially determined by the country code selected,
but this can be overridden by using the webserver.
Conference Calls
The DHY-04 has the ability to conference 2 calls on separate DHY-04 units
together so that you need only to use 1 telco module on the mixer. These
units are linked by a CAT5 cable (wired as shown below) via the RJ45
connectors on the rear of the units. The conference calls record feature is
unavailable on the DHY-04.
Note: This is not a standard CAT5, or CAT5 crossover, cable.
Establishing calls on both units will allow each caller to hear a mix of the
clean-feed station output and the other caller. The feed to the mixer will
contain a mix of both received calls.
Figure 3-2: Conference Port Cable Connections.
The conference port cable simple cross-connects the Conference Input
(Phase and Non-Phase) signals to the Conference Output (Phase and Non-
Phase) signals respectively. It is available as an accessory, DHY-04CONF.
Using the Conference Port as a Record Output
If you are not using the conference port, it can be used to provide a
balanced audio output from the Conference Output Phase and Non-Phase
pins. This output will contain just the caller signal unless the webserver
option is selected (Configuration-Misc, page 27), which will create a mix
of caller and sender on the record output.
Using the Conference Port to Share a Stereo Digital Audio
Connection Between Two DHY-04 Units
The DHY-04, when connected to a digital input, has the ability to receive
a stereo signal. Normally just the left channel is used for the hybrid, but
the unit can be set to use the conference port to feed the right channels
to another hybrid, i.e. you can use a stereo signal to feed two hybrids
automatically.
Set the first DHY-04 unit to Digital Master Conference mode in the
webserver (Configuration-Misc, page 27) and use a crossover wired
connection to another DHY-04 which is set to Digital Slave Conference
mode (Configuration-Misc, page 27). Now the first unit provides a
telco connection via the left channels and the slave unit provides a telco
connection via the right channels.
Bekijk gratis de handleiding van Sonifex DHY-04, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sonifex |
| Model | DHY-04 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11611 MB |
