Sonicware LIVEN BASS&BEATS handleiding
Handleiding
Je bekijkt pagina 45 van 48
System settings
45
This section explains settings related to the system.
Explanations assume that the function setting state has
been enabled.
Press and hold
to enable the function setting state.
(Exceptions are checking the system version, conducting
a factory reset, and updating the rmware.)
Setting the automatic power o function
① Press SYSTEM and select A.PWR.
② Turn the
VALUE knob to select the automatic
power o setting.
• Automatic power o has four settings.
1. OFF: Automatic power o is disabled.
2. 30 minutes (0.5H on display): Power will turn o
automatically after 30 minutes without operation.
3. 1 hour (1H on display): Power will turn o auto
-
matically after 1 hour without operation.
4. 3 hours (3H on display): Power will turn o auto
-
matically after 3 hours without operation.
5. 6 hours (6H on display): Power will turn o auto
-
matically after 6 hours without operation.
• Unsaved data will be cleared when the power turns
o automatically. Always save data that is needed.
Setting the battery type
① Press SYSTEM, and select BATT.
② Turn the
VALUE knob to select the type of bat
-
tery.
• 3 types of batteries can be selected.
1. Alkaline (ALKL on display)
2. Nickel-metal hydride (NIMH on display)
3. Lithium (LTHM on display)
• The remaining charge shown could be higher than
the actual amount depending on the type of re
-
chargeable battery.
• Please set this correctly because it eects opera
-
tion time.
Setting the master tuning
① Press SYSTEM, and select TUNE.
② Turn the
VALUE knob to set the master tuning.
• The master tuning setting (in cents) will be shown
on the display.
• The adjustment range is − 75 – +75.
Checking the system versions
① While pressing , press and hold the POWER
switch.
• The LIVEN BASS&BEATS will start up, and VER. will
appear on the display.
② Press
to select the system version.
• The system version (S M.m) is shown on the display
(M: major version, m: minor version).
• Press
to show the boot version (BM.m on dis-
play). Press to show the preset version (PM.
m on display).
• Press the same page button again to show the
build number.
• Press
to start up normally.
Outputting bass and drums separately to
left (L) and right (R) channels
① Press SYSTEM, and select SPLT.
② Turn the
VALUE knob, and select ON.
• The bass will be output on the L channel and the
drums will be output on the R channel.
Setting the clock source
① Press CLOCK, and select SRC.
② Turn the
VALUE knob to set the clock source.
• The clock source is shown on the display.
• Four types of clock sources can be selected.
1. INTERNAL (INT on display): Use LIVEN
BASS&BEATS internal clock.
2. MIDI: Use MIDI clock.
3. SYNC: Use SYNC IN clock.
Bekijk gratis de handleiding van Sonicware LIVEN BASS&BEATS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sonicware |
| Model | LIVEN BASS&BEATS |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6180 MB |
