Sonicware CyDrums handleiding
Handleiding
Je bekijkt pagina 72 van 231
AMP page
Setting the send signal amount to the Reverb
1
Press the
AMP
pad to open the AMP page.
2
Press the
Auxiliary left buttons ENV/BUS to open the BUS
page.
3
Turn
A knob to select the output MFX.
4
Turn
B knob to adjust the amount of send signal to the reverb.
• If a BUS other than MFX is selected, you cannot send signal to
the reverb.
• The procedures above are only applicable when the eect
routing setting ( → P.75) is set to conguration 1, 3, or 5.
Setting the Sidechain Compressor Trigger Signal
1
Press the
AMP
pad to open the AMP page.
2
Press the
Auxiliary left buttons ENV/BUS to open the BUS
page.
3
Turn
C knob to adjust the amount of send signal to the SC
COMP trigger.
• This is only applicable when the MFX setting ( → P.79) is set
to SC COMP.
72
Bekijk gratis de handleiding van Sonicware CyDrums, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sonicware |
| Model | CyDrums |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 27359 MB |
