Sommer RDC Vision+ handleiding

50 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 8 van 50
8
2.1 Basic safety instructions for
operation
Follow the basic safety instructions listed below.
Danger if not observed!
Serious injury or death may result if safety instructions are
not observed.
It is imperative to comply with all safety instructions!
Danger due to electric current!
Contact with live parts may result in electric current ow-
ing through the body. Electric shock, burns, or death may
result.
All work on electrical components must be carried out
by qualied personnel!
Disconnect the mains plug before working on the de-
vice!
If an accumulator is used, disconnect it from the control
unit!
Check that the device is disconnected from the voltage
supply!
Secure it against being switched back on!
Before commissioning, it is essential to ensure that the
specications on the type plates of the operator and the
control unit match.
All electrical wires must be tted tightly and secured
against shifting.
In case of a three-phase current connection, make sure
that the direction of rotation is clockwise.
Installations with a xed mains connection require an
all-phase mains circuit breaker with appropriate fuses.
Regularly check power cables and wires for insulation
defects or cracks. If a fault is detected, take the system
out of operation immediately and repair the damage.
Before switching on for the rst time, make sure that all
plug-in terminals are in their correct positions.
2. General safety instructions
Danger due to use of the control unit with incorrect
settings or when it is in need of repair!
If the control unit is used despite incorrect settings or if it is
in need of repair, severe injury or death may result.
The control unit may only be used with the required
settings and in the proper condition.
Have faults repaired professionally without delay.
Danger caused by hazardous substances!
Improper storage, use or disposal of accumulators, batter-
ies and components of the control unit are dangerous for
the health of humans and animals.
Store accumulators and batteries out of the reach of
children and animals.
Keep batteries and accumulators away from chemical
and thermal inuences.
Do not recharge batteries and defective accumulators.
All components of the control unit, including old accu-
mulators and batteries, must be disposed of correctly
and not with household waste.
Danger for trapped persons!
Persons may be trapped inside the garage. If trapped per-
sons cannot free themselves, severe injury or death may
result.
Test the operation of the manual emergency release (if
installed) regularly from inside and if necessary, also
from outside.
Danger caused by components projecting into publicly
accessible areas!
Parts must not project into public roads or footpaths. This
also applies while the door is moving. Persons and animals
may be seriously injured.
Keep public roads and footpaths clear of projecting
parts.
Danger due to being pulled in!
Persons or animals in the movement area of the door may
be trapped and pulled along with the door. Severe or fatal
injuries may result.
Keep clear of the movement area of the door.
Danger of crushing and shearing!
If the door moves and there are persons or animals in the
movement area, crushing and shearing injuries may be
caused by the mechanism and safety edges of the door.
Only operate the door when you have a direct view of
the movement area.
The danger zone must be visible during the entire door
operation.
Never enter the range of movement of the door.
Keep persons and animals away from the danger zone.
Never reach into moving mechanical components while
the door is moving.
Always keep the moving door in sight.

Bekijk gratis de handleiding van Sommer RDC Vision+, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkSommer
ModelRDC Vision+
CategorieNiet gecategoriseerd
TaalNederlands
Grootte5752 MB