Sommer ASB-6010A handleiding
Handleiding
Je bekijkt pagina 13 van 61
13
Transport
The barrier is transported to the operator’s premises by a specialist
dealer or by a haulage company commissioned by the specialist dealer.
After the contractually regulated handover of all responsibility to the
operator, the operator must make sure that the barrier is safely and properly
transported.
It is compulsory to observe the following information regarding transport:
¾ Do not stack the packaging units on top of each other.
¾ Transport the packaging units in the position specied on the
packaging.
¾ Even during transport, observe the ambient conditions (temperature,
humidity, etc.) specied by the manufacturer.
¾ Always make sure that the barrier is transported without impact and
jolts.
¾ Always secure the loads to be transported against falling, tipping over,
and damage.
Unloading and in-house transport
WARNING
During this work, dangers may arise, for example due to
uneven surfaces, sharp edges or the use of operating and
auxiliary materials.
Body parts may be injured.
¾ Wear suitable, close-tting protective work clothing
(as a minimum, safety helmet, safety shoes, and
safety gloves). Do not wear long hair loose.
DANGER
Falling load!
During unloading, the load may fall and cause severe or
fatal injuries.
¾ Use lifting equipment designed for the weight of the
load.
¾ Never step under suspended loads.
Check packaging units for externally visible transport damage or other
damage. If damage is found, have it conrmed by the haulage company
and inform SOMMER Antriebs- und Funktechnik GmbH in writing
immediately after delivery.
After unloading, store the barrier until setup. For this purpose, the operator
of the barrier may have to transport the barrier from the place of unloading
to the storage location.
If this is the case, observe the following information regarding unloading
and intermediate transport:
¾ For unloading and in-house transport, at least two persons are
required.
¾ Use only suitable, tested, and standardised lifting equipment (fork lift
truck, mobile crane, overhead crane) and attachments (slings, lifting
belts, sling ropes, chains).
¾ When selecting the lifting equipment and attachments, always take
the maximum load-bearing capacities into consideration.
¾ Always make sure that the barrier is unloaded and transported without
impact and jolts.
¾ Do not stack the packaging units on top of each other.
¾ After unloading, do not remove the packaging materials or transport
locks.
Storage
NOTE!
The operator and other assemblies of the barrier may
be damaged by incorrect storage.
Irreparable damage to the barrier may be the result.
¾ Observe the following storage conditions on rst
delivery and during intermediate storage!
For transport, the packaging units are packed in a plastic lm which
protects them against environmental inuences.
¾ Do not remove or damage this plastic lm. If necessary, additionally
cover the assemblies.
¾ Store the packaging units in enclosed, dry rooms in which they are
protected against moisture and UV radiation.
¾ Store the packaging units at a storage temperature from –20°C to
+60°C.
¾ Store the packaging units in the position specied on the packaging.
¾ Do not stack the packaging units on top of each other.
¾ Leave room for unhindered passage.
Transport / Unloading / Storage
Bekijk gratis de handleiding van Sommer ASB-6010A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sommer |
| Model | ASB-6010A |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7965 MB |
