Solid State Logic SSL 2+ MKII handleiding
Handleiding
Je bekijkt pagina 26 van 61
Input Channels
This section describes the controls for Channel 1. The controls for Channel 2 are exactly the same.
+48V
This switch enables phantom power on the combo XLR connector, which will be sent down the XLR microphone cable to
the microphone. Phantom power is required when using Condenser or Active Ribbon microphones. BE AWARE! Dynamic
& Passive Ribbon microphones DO NOT require phantom power to operate and can damage some microphones if
improperly engaged.
LINE
This switch changes the source of the channel input to be from the balanced Line input. Connect line-level sources (such
as keyboards and synth modules) using a TRS Jack cable into an input on the rear panel. The LINE input bypasses the
pre-amp section, making it ideal to connect the output of an external preamp to if you so wish. When operating
in LINE mode, the GAIN control provides up to 27 dB of clean gain.
HI-PASS FILTER
This switch engages the Hi-Pass Filter with a cut off frequency at 75Hz with a 18dB/Octave slope. This is ideal for removing
unwanted low-end frequencies from an input signal and cleaning up unnecessary rumble. This is suitable for sources such
as Vocals or Guitars.
LED METERING
Home Sign in / Register
10/30/24, 12:24 PM
SSL 2+ MKII User Guide – SSL Support
https://support.solidstatelogic.com/hc/en-gb/articles/20859917333789-SSL-2-MKII-User-Guide#ssl-2-mkii-user-guide-0-0
26/61
Bekijk gratis de handleiding van Solid State Logic SSL 2+ MKII, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Solid State Logic |
| Model | SSL 2+ MKII |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8952 MB |
