Soler & Palau UTBS PRO-REG ECOWATT Handleiding (96 Pagina's)

Handleiding

61

When the ETD cable and 4-Way electrical supply plug have been connected, perform the

following sequence of operations:

UTBS 1.0

Isolate the electrical power supply again. Re-connect all of the other cables to the Corrigo

controller and ﬁ nally re-energise UTBS PRO-REG and the reset procedure is now complete.

The run mode of the system (I.e VAV/CAV/COP) should now be re-set-up, together with

ensuring that the additional parameters (K-Constant, heater type etc.) are correct.

CONTROLLER RECONFIGURATION

¡IMPORTANT!

After reset the controller, it is necessary to reconﬁ gure the unit, as the factory set-

tings are deleted.

Bekijk gratis de handleiding van Soler & Palau UTBS PRO-REG ECOWATT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.