Smeg SAW7514 handleiding

Handleiding

1234567891011121314151617181920/ 20

Afdrukken

Je bekijkt pagina 3 van 20

3 / EN

Washing Machine / User’s Manual

2 Installation

RefertothenearestAuthorisedServiceAgentforinstallation

oftheproduct.Tomaketheproductreadyforuse,review

the information in the user manual and make sure that the

electricity,tapwatersupplyandwaterdrainagesystemsare

appropriatebeforecallingtheAuthorizedServiceAgent.If

theyarenot,callaqualifiedtechnicianandplumbertohave

any necessary arrangements carried out.

C

Preparationofthelocationandelectrical,tapwaterand

waste water installations at the place of installation is

undercustomer'sresponsibility.

B

warning: Installationandelectricalconnectionsof

theproductmustbecarriedoutbytheAuthorized

ServiceAgent.Manufacturershallnotbeheldliablefor

damagesthatmayarisefromprocedurescarriedoutby

unauthorizedpersons.

A

warning: Priortoinstallation,visuallycheckiftheproduct

hasanydefectsonit.Ifso,donothaveitinstalled.

Damagedproductscauserisksforyoursafety.

C

Make sure that the water inlet and discharge hoses

aswellasthepowercablearenotfolded,pinchedor

crushed while pushing the product into its place after

installation or cleaning procedures.

2.1 Appropriate installation location

• Placethemachineonarigidfloor.Donotplaceitona

long pile rug or similar surfaces.

• Totalweightofthewashingmachineandthedryer-with

full load- when they are placed on top of each other

reachestoapprox.180kilograms.Placetheproduct

on a solid and flat floor that has sufficient load carrying

capacity!

• Donotplacetheproductonthepowercable.

• Donotinstalltheproductatplaceswheretemperature

mayfallbelow0ºC.

• Placetheproductatleast1cmawayfromtheedgesof

other furniture.

2.2 Removing packaging reinforcement

Tiltthemachinebackwardstoremovethepackaging

reinforcement.Removethepackagingreinforcementby

pullingtheribbon.

2.3 Removing the transportation locks

A

warning: Donotremovethetransportationlocksbefore

taking out the packaging reinforcement.

A

warning: Removethetransportationsafetyboltsbefore

operatingthewashingmachine!Otherwise,theproduct

willbedamaged.

1.Loosenalltheboltswithasuitablespanneruntilthey

rotate freely (C).

2.Removetransportationsafetyboltsbyturningthem

gently.

3.AttachtheplasticcoverssuppliedintheUserManualbag

into the holes on the rear panel. (P)

C

Keepthetransportationsafetyboltsinasafeplaceto

reusewhenthewashingmachineneedstobemoved

again in the future.

C

Never move the product without the transportation safety

boltsproperlyfixedinplace!

2.4 Connecting water supply

C

Thewatersupplypressurerequiredtoruntheproductis

between1to10bars(0.1–1MPa).Itisnecessaryto

have10–80litersofwaterflowingfromthefullyopen

tap in one minute to have your machine run smoothly.

Attachapressurereducingvalveifwaterpressureis

higher.

C

Ifyouaregoingtousethedoublewater-inletproduct

as a single (cold)water-inletunit,youmustinstallthe

suppliedstoppertothehotwatervalvebeforeoperating

theproduct.(Appliesfortheproductssuppliedwitha

blindstoppergroup.)

A

warning: Modelswithasinglewaterinletshouldnotbe

connectedtothehotwatertap.Insuchacasethelaundry

will get damaged or the product will switch to protection

mode and will not operate.

A

warning: Donotuseoldorusedwaterinlethosesonthe

newproduct.Itmaycausestainsonyourlaundry.

1.Connectthespecialhosessuppliedwiththeproductto

the water inlets on the product. Red hose (left) (max. 90

ºC)isforhotwaterinlet,bluehose(right)(max.25ºC)is

for cold water inlet.

A

warning: Ensure that the cold and hot water connections

are made correctly when installing the product.

Otherwise,yourlaundrywillcomeouthotattheendof

the washing process and wear out.

2.Tightenallhosenutsbyhand.Neveruseatoolwhen

tightening the nuts.

3. Open the taps completely after making the hose

connection to check for water leaks at the connection

1234567891011121314151617181920/ 20

Bekijk gratis de handleiding van Smeg SAW7514, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Gerelateerde producten van Smeg (Wasmachine)

Handleiding bekijken

Smeg WNP84SEAUK

Wasmachine - handleiding

Handleiding bekijken

Smeg WNP84SEAIN1

Wasmachine - handleiding

Handleiding bekijken

Smeg SAW816

Wasmachine - handleiding

Andere merken in Wasmachine