Smeg DWA6224X4 handleiding
Handleiding
Je bekijkt pagina 39 van 39
User instructions
39
FAULT
DESCRIPTION
E7
Turbine flow-regulator malfunction
(for the relevant models only)
The appliance is not able to "measure" the amount
of water loaded accurately. Interrupt the program
and switch off the dishwasher. Switch the
dishwasher back on, program it again and start the
washing cycle. If the problem persists, contact the
after-sales service.
E8
Alternate washing system malfunction
Interrupt the program and switch off the dishwasher.
Switch the dishwasher back on, program it again and
start the washing cycle. If the problem persists, contact
the after-sales service.
E9
Water intake system malfunction
Contact the after-sales service.
E11
Wash motor pump does not work
Light off
Light on
Light flashing
If an alarm occurs the appliance interrupts the program in progress and signals
a fault.
Alarms E1, E2, E3, E4, E8 and E9 interrupt the current program
immediately.
The E5, E6 alarms interrupts the running program, once the cause is
resolved, the program will continue to run.
The alarm E7 is shown at the end of the cycle however, the dishwasher
has completed the cycle without causing any damage to the machine.
Alarm E11: Contact your authorised Service Centre
To “reset” an alarm is necessary:
Open and close the door, or turn off and on the machine. At this point it is
possible to program the dishwasher again.
If the malfunction persists, contact your authorised Service Centre.
Bekijk gratis de handleiding van Smeg DWA6224X4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Smeg |
| Model | DWA6224X4 |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 6083 MB |
