SMART Technologies SBID-MX255-V2 handleiding

Niet gecategoriseerd

SMART Technologies

45 pagina's

PDF beschikbaar

Handleiding

Chapter 4

Connecting computers and other devices

smarttech.com/kb/171554 xxxiii

NOTES

Install SMART software on any computers you connect to the display (see Installing and using

SMART software on pagexxx).

l Your organization’s installers might have connected cables to the display and run the cables behind

a wall or under the floor to a desk or table where you can place your computer.

Viewing a connected computer’s input

To view a connected computer’s input

1. Connect the computer to the display.

Press the Input button on the front control panel or the remote control.

The display shows thumbnails of the devices that are connected to the display’s inputs:

NOTE

A thumbnail with Touch enabled indicates a USB cable is connected between the display and

device and touch is available.

A gray thumbnail indicates no device is connected to an input.

A black thumbnail indicates a device is connected to an input but is in Standby mode.

A thumbnail showing a preview screen indicates an active device is connected to an input.

3. Tap the computer’s thumbnail.

Setting a connected computer’s resolution and refresh rate

The following table presents the recommend resolutions and refresh rates for the display’s HDMI1, HDMI 2,

and HDMI 3 input sources:

Resolution Input source aspect ratio Mode Refresh rate

3840 × 2160 16:9 UHD / 2160p 59.94 Hz / 60 Hz

50 Hz

29.97 Hz / 30 Hz

25 Hz

23.98 Hz / 24 Hz

Bekijk gratis de handleiding van SMART Technologies SBID-MX255-V2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.