Simpson TM2810241E handleiding
Handleiding
Je bekijkt pagina 39 van 132
Page 37
Before each use, check engine for loose or damaged parts, signs of oil or fuel leaks, and/or
any other condition that may aect proper operation. Always keep all safety guards in place
and in proper working order. Repair or replace all damaged or defective parts immediately.
For safety reasons, the manufacturer recommends all engine service and repairs (including
emission control devices and systems) be performed by an authorized service center. All
warranty replacements or repairs must be performed by an authorized distribution or service
center. To nd an authorized service center near you, obtain information about how to make
a warranty claim, or to make arrangements for authorized warranty repairs, please call
1-833-362-7368 or email cservice@fna-group.com.
For all other information on engine maintenance, refer to the engine manual.
Engine Maintenance
STORAGE AND TRANSPORTATION
Storing for Two Months or Less
1. Fill fuel tank per the OPERATING CHECKLIST section of this manual then add a fuel
stabilizer per the manufacturer’s recommendations. NOTE: Using a fuel stabilizer (sold
separately) when storing gasoline may help prevent problems related to alcohol blended
fuels in outdoor power equipment engines. Always follow the instructions provided by the
fuel stabilizer manufacturer to mix and use correctly.
5. Shut o the water supply. Remove the water supply hose.
2. Complete the steps in the OPERATING CHECKLIST, CONNECTING HOSES, and
PRIMING THE PUMP sections of this manual.
3. Start the engine per the STARTING section of this manual and run it for ten (10) minutes
to allow the stabilized fuel to circulate through the entire fuel system. Be sure to squeeze the
trigger to keep water owing through the pump and spray gun to avoid overheating.
4.
Turn the engine switch to the OFF position.
9. Store the pressure washer in a clean, dry area out of direct sunlight.
6. Squeeze the spray gun trigger to relieve the pressure in the hose and pump then drain
the high pressure hose. Disconnect the high-pressure hose from the pump and spray gun.
7.
Allow the engine to cool completely.
8.
Protect the pump by using SIMPSON
®
Pump Guard per the USING PUMP GUARD
section of this manual.
Bekijk gratis de handleiding van Simpson TM2810241E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Simpson |
| Model | TM2810241E |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 12853 MB |
