Simpson TM2810241E handleiding
Handleiding
Je bekijkt pagina 16 van 132
Page 14
Before connecting a water supply hose, the water supply must provide an uninterrupted
source of clean, cold water of at least the rated gallons per minute (GPM) of the pressure
washer and 20 pounds per square inch (PSI) of pressure. However, we recommend that the
water supply is at least 10% above the rated GPM of the pressure washer. Once a proper
water supply is secured, follow the instructions below to connect both the water supply and
high-pressure hoses to the pressure washer. DO NOT use hot water. Use cold water only.
CONNECTING HOSES
(not included)
Verify the inlet screen is free of
any dirt or debris and is in place
with the convex side facing out.
1.
Turn on the water supply and
run for 30 seconds to purge any
debris from the supply hose.
Then, turn o the water supply
and thread the water supply hose
into the pump inlet.
2.
While pulling back on the pump
outlet collar, insert the hose
connector then release the collar.
Gently tug on the hose to make
sure it is locked.
3.
While pulling back on the hose outlet collar, insert the spray gun connector
(not included) then release the collar. Gently tug on the hose to make sure it
is locked.
4.
Bekijk gratis de handleiding van Simpson TM2810241E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Simpson |
| Model | TM2810241E |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 12853 MB |
