Sime FUEL EV handleiding
Handleiding
Je bekijkt pagina 38 van 100
38
EN
1 SAFETY
1.1 General information
The instructions for installing, commissioning and servicing
the burner are addressed to technicians of professional heating
companies enabled to perform the aforementioned activities.
The instructions contain indications and information for moving,
handling, activating, adjusting, servicing and removing the ap
-
pliance and disposing of its components at the end of their life.
Conformity to the specified information and the regulations in
force are the prerequisites for a safe job.
The burner cannot be installed outdoors, unless it is installed
in a boiler suitably designed for this purpose, therefore also
equipped with a control panel and accessories suitable for man
-
aging the anti-freeze function.
This manual
must be kept near the product where it can be con
-
sulted by all operators who intervene in the activities.
a
WARNING
The installation, commissioning and maintenance ac-
tivities must be entrusted only to personnel of specifi-
cally qualified companies of the sector.
1.2 Intended use
The burner is a heat source for space heating and domestic hot
water production systems, in which the heat-transfer fluid is
water.
Any additional and broader application goes beyond the specific
intended use.
To prevent risks, the burner can only be used:
– for its specific intended use;
– in the appropriate safety conditions;
– by observing the installation, commissioning and mainte
-
nance instructions;
–
in conformity to the maximum and minimum operating val-
ues;
–
in conformity to all the necessary maintenance activities;
– by immediately solving any malfunctions that can jeopardise
safety;
– by keeping in a legible condition any notes and precautions
attached to the product;
1.3 Primary dangers
The following indications concern “residual risks” which must
be pointed out so that the owner, manager and operators can
fully understand them and adopt a responsible approach.
They derive from the risk analysis conducted by the Research
& Development staff as imposed by the European standard EN
267 and the directives in force relevant to the sector (Machinery,
LVD, EMC directives).
f
ELECTRICAL HAZARD
– Contact with live electrical compo-
nents can lead to serious accidents.
– Only professionally trained and qual-
ified personnel can intervene on the
electric
al system.
– Prior to any intervention, disconnect
the power supply to the system through
the main switch, check that there is no
voltage and verify that the system can-
not restart.
–
If the product’s electrical insulation is
damaged, intervene promptly to re-
store its correct rating.
c
WARNING: HOT SURFACE
– Contact with high-temperature com-
ponents can cause superficial burns of
varying intensity.
– Operators must wear adequate cloth-
ing and personal protective equipment.
–
They must ensure that all the compo-
nents are at room temperature before
carrying out any maint
enance opera-
tions.
a
LOSS OF FUEL
– Loss of fuel can trigger fires.
– It may be dangerous if inhaled and can
cause dermatitis.
– If oil mist forms, use a protective face
mask with a filter for organic vapours
and a particulate filter.
– Promptly intervene by removing the
cause of the loss and, if it is related to
a maintenance activity, use appropriate
personal protective equipment.
Bekijk gratis de handleiding van Sime FUEL EV, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sime |
| Model | FUEL EV |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 26611 MB |
