Silvercrest SRR 3.7 E6 handleiding
Handleiding
Je bekijkt pagina 11 van 98
9
GB
7.2 Shaving attachment/
blade unit
Dry cleaning of the shaving at-
tachment
Clean the 3 shaving heads2 after each
shave using the cleaning brush17.
1. Press the release button4 on the shav-
ing attachment3, so that the blade
unit2 opens.
2. Carefully tap the blade unit2 to empty
it.
3. Remove the hair remnants by using the
cleaning brush17.
Wet cleaning of the blade unit
The shaving heads2 of the shaving attach-
ment3 can be cleaned with water.
1. Press the release button4 on the shav-
ing attachment3, so that the blade
unit2 opens.
2. Clean the blade unit2 under running
water. Allow the water to flow through
the shaving heads2 from the inside to
the outside.
3. Allow the parts to dry completely.
4. Close the blade unit2, so that it clicks
into place.
Thorough cleaning of the blade
unit
An integrated timer in the device adds up
shaving times. After approx. 30 minutes of
shaving, the cleaning symbol11 starts
flashing. It reminds you of the thorough
cleaning that you should regularly perform.
If you switch off the device while the clean-
ing symbol is flashing, the timer will start
counting shaving times again from the be-
ginning.
1. Press the release button4 on the shav-
ing attachment3, so that the blade
unit2 opens.
2. Figure D: pull the blade unit2 off the
shaving attachment3 by overextending
it.
3. Figure E: carefully turn the locking
wheel14 marked with arrows against
the direction of the arrows, until the
holder for shaving heads15 can be lift-
ed off.
4. Clean all parts under running water,
and then allow them to dry completely.
5. Reassemble the blade unit2.
6. Figure F: carefully turn the locking
wheel14 in the direction of the arrows,
until the holder for shaving heads15
can no longer be lifted off.
7. Push the blade unit2 and the shaving
attachment3 back together and close
the blade unit2, so that it clicks into
place.
8. Push
the shaving attachment3
back
onto the shaver
6
and ensure that it
clicks firmly into place.
NOTE: for thorough cleaning, an ultrasonic
bath is recommended.
7.3 Beard trimmer
attachment
• Remove the hair remnants from the
beard trimmer attachment1 by using
the cleaning brush17 supplied.
• Every 6 months or so, apply a few
drops of oil to the cutting edge of the
beard trimmer attachment1. Using a
soft, lint-free cloth, wipe off the surplus
oil, if necessary. Only use acid-free oil
(e.g. sewing machine oil) as an alterna-
tive to the oil18 supplied.
__426131_2307_B7.book Seite 9 Freitag, 6. Oktober 2023 7:43 07
Bekijk gratis de handleiding van Silvercrest SRR 3.7 E6, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Silvercrest |
| Model | SRR 3.7 E6 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9827 MB |
