Silvercrest SHLF 2000 E4 handleiding
Handleiding
Je bekijkt pagina 12 van 149
GB/IE/NI/CY/MT12
3. Before you start the device
3.1 Device Installation
Remove all packaging material and all trans-
port bracing from the device.
For a safe and trouble-free running of the device,
choose the installation location which meets the
following requirements:
The floor should be firm, flat and horizontal.
Keep the following minimum clearances from
the device housing: 50 cm from its lateral side,
50 cm above, 50 cm from its rear side and
1 m from its front side.
Do not place the device in a hot and wet or
very humid environment or near combustible
material.
The socket should be easily accessible so that
the mains connection cable can be easily
disconnected, if necessary.
Temperature range: from 10 to +35 °C
Please note: When you use the device the first
time, a slight odour may occur.
3.2 Remote control: How to insert or change
the battery
The remote control unit is delivered together with
a lithium button cell
12
. To enable the remote
control, remove the plastic tape that protrudes
from the battery compartment
10
(see Figure 1).
1
If the remote control battery needs to be re-
placed, insert a new 3-volt lithium button cell.
Pay attention to the type of lithium button cell
(CR2025).
Press the tab
11
on the battery compartment
10
of the remote control toward the centre. Now pull
out the battery compartment
10
(see Figure 2).
2
10
11
12
Remove the old battery
12
.
Insert a new 3V-button-cell battery (type
CR2025). Pay attention to the correct polarity.
Push the battery compartment
10
back into the
remote control unit until the tab
11
snaps into
place.
4. Starting Up
4.1 Standby mode
Plug the unit into a power outlet. Set the on/off
button
1
to the „ “ position to supply power
to the unit. A short beep sounds.
The operation light flashes on the display
while the unit is in standby mode.
4.2 Switch on the unit
Press button
1
/
A
to switch on the product.
The appliance starts directly in appliance freeze
protection mode.
4.3 Switch off the unit
To return the unit to standby mode after
operation, press button
1
/
A
.
Bekijk gratis de handleiding van Silvercrest SHLF 2000 E4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Silvercrest |
| Model | SHLF 2000 E4 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 12499 MB |
