Silvercrest SDI 2800 B3 handleiding
Handleiding
Je bekijkt pagina 23 van 98
SilverCrest SDI 2800 B3
English - 21
If you remove the pan from the induction hotplate when in use, the display (7) shows
"E0" and a beeper sounds every 2 seconds. The beeper stops sounding after approx. 60
seconds. The display (7) of the corresponding heating zone (1, 3) continues to show "–
H –" as long as the surface temperature of the heating zone (1, 3) is greater than
60 °C. If the temperature drops below 60 °C, the display (7) of the heating zone (1, 3)
shows "– L –". The fan may continue to run for up to a minute.
The only way to hide the “– H –” and “– L –” symbols from the display (7) is by
disconnecting the product from the mains or by switching the induction hotplate on
again.
After switching on, the default power setting is L05 for the left heating zone (1) and L03
for the right heating zone (3).
1. Connect the induction hotplate to a live mains socket using the power cable (2). A beeper then
sounds and the display (7) of the heating zone (1, 3) shows "– L –" or "– H –" depending on the
temperature.
2. Place a pan on one of the heating zones (1, 3).
Place the cookware centered on the heating zone
(1, 3).
Bottom diameter 10 to 22 cm
Don't use both heating zones (1, 3) for only one
piece of cookware.
Bekijk gratis de handleiding van Silvercrest SDI 2800 B3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Silvercrest |
| Model | SDI 2800 B3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7096 MB |
